Bravo Eric. and I do not believe there is any difference in AC vs DC resistance heating element...but ask an electrician.

Sorry, guys. I did exactly the same thing as Gary Silver, and the bearing was never installed.

Michael, Have you used the VE-Config software, or other means, to check the output hz on your system when connected to 60hz shorepower? Does it show that you're getting 50hz output? When I was

The stated inverter loss you mentioned is a bit simplified. A deeper look will allow you to make the best decision given your usage patterns, which is different than everyone else's. This may be

The 24 vdc breaker on the 24 volt panel controls the power to activators on the windlass, the sail motors and winches but not to the anchor wash. The anchor wash has direct power from the C/B panel

Mark Thanks for your reply. Yes, I did check the breaker.. it was not tripped, but it may be suspect since it had been replaced... I’m not on the boat today, but I will take photos next week.

Hi Matt, Great that you got a good sail in today! Thanks for that. I’m also 6’1” and it’s good to have that frame of reference. You did great and it was a super informative session. I hope to

Andre, I am unsure if the solenoid is the same on the Mango as the SM. If it is, it is a product used in forklift trucks. This should help you find one (not sure where you are located). Perhaps you

Oh, you asked me how tall I was, and the signal stopped working... I’m a hair over 6’1” ~~~⛵️~~~Matt

Oh, and we went sailing on a beautiful day today! ~~~⛵️~~~Matt

Thanks! We had a blast. Of course, we thought of lots of other stuff worth demonstrating, AFTER the presentation ended! Thanks for the opportunity, and it was a pleasure to play with

Hi Reudi; To clarify, in order for the sensor to be isolated, you need two wires. You cannot have an isolated single wire sensor, since it will utilize the engine block as the negative leg of the

I have a 1988 Mango no.71. On recommissioning this spring, the electric outhaul for the mainsail is not working. A quick look by a yard worker suggested the solenoid might be bad. Can someone give me

Eric, Excellent configuration. Where do you get $C heating elements? And is there really a difference between AC and DC elements? Seems it would just be a resistance heater? Different

On May 17, 2020, at 8:51 AM, karkauai via groups.io <karkauai@...> wrote:  *** Attention: This is an external email. Use caution responding, opening attachments or clicking on links. *** Hi

Hi Reudi, I have a Yanmar, so I can't be specific about your Volvo needs, but in general... To purchase an (isolated ground) two-wire pressure or temp. SWITCH, you need to know the thread size and

Hi Michael & Robyn Please add one to the order for us, too. Shipping to Maryland. My private email below. Kent and Iris Kristy SM 243 karkauai "at "yahoo "dot" com

Craig...adding as much solar completly changed how we cruised. Before i would run a honda generator as we don't have a onboard diesel one. You really can power the santorin with 100% solar.

Hi John, Like Gary, the chrome on my original rigging looked like new when I had her re-rigged at 13 years old. The new rigging was from a well-respected company in England (sorry, I don't remember

Thanks again Matt & Cindy for the tour, and thanks Bill for setting it all up! I’ve processed the zoom video and added subtitles. You can find it at https://youtu.be/PK2yf-Hzr58 Best, Tilo