Amel 54 and Amel 55 owners with B&G H3000 or H5000: Did you know that if your B&G Sonic Speed fails, there is a user-programmable setting in the H3000 & H5000 processor to use SOG from your GPS

Hi Stuart, I do not know how your rudder stock is configured as Kimberlite is a 53. If is like mine…. The nut on my quadrant is about 60 mm. If I had a wrench on board that size it would not fit

Stuart, The last time I did this on a 55, I removed the quadrant because it was easier to do with the quadrant removed. I believe you might be able to do it without the removal, but that will depend

Hello Jorg, Thank you very much for your reply with photograph. We have the large Amel spanner but no inspection plate... Do we have to remove the quadrant and it’s connections to access the rudder

Hi Dan We made our inspections hatches in the diesel tank winter 2012-2013 and we used industrial rubber suitable for petro chemical products. No problem what so ever, so far. Knock on

Posted by Amel about 1 hour ago: Measures related to COVID virus-19 The situation related to the fight against COVID-19, the government decisions and the media pressure have impacted our production

Hi Daniel, I removed the inspection port about 10 years ago. I used a truck inner tube as the material to make a new gasket. I have had no problems since. I opened the tank because there was debris

Hi all, I posted this question on a previous thread about fuel tank cleaning. And I've not found a good previous discussion of the topic on the forum. I'm looking for the right material to replace the

I agree that it is about 100-150 liters left in the tank. 1)I would also suggest that it is a good time to remove the inspection plate on the tank and take a look at the inside of the tank. You

Hi Craig,. Thanks for the recco on the fluid. Yes, unfortunately coolant is another of those mystery fluids where you are either in a well stocked parts store and faced with a myriad of mind boggling

I did, just yesterday. Had about 100L left. However, I’m not sure if these gauges are all calibrated the same. Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Hi Dan, Others have commented that you should be fine with what you've got plus, perhaps, some sheet gasket material. Under your #3 though - tricks, traps or learnings - I'd add to be sure to replace

i am not in this situation (yet) but still curious. Has anyone ever taken their fuel level down to the beginning of the red area on the gauge and measured actual amount in the tank using the

Thanks for the replies Eric and Bill. I was able to find some coolant in a hardware store just an hour before the closed the stores in Les Saintes and notified all of the boats on the moorings that

Dan, Where did you get the pump from? There are sheets of gasket material and a O Ring making kit at the same source as the pump. 🙄 Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 |

If you do not have the gasket you can go to an auto supply and get gasket material. It comes in sceehs and with a razor knife and scissors you can make a gasket. An o ring should not be difficult to

Good morning all, it is time for me to replace the fresh water pump on the YANMAR 4JH3-HTE (100hp Turbo) diesel. The original plan was to have it done in Martinique, but it has started to leak from

Hi Nick There is a very competent and highly regarded boat builder / surveyor Rob Carpenter living near Picton in Waikawa Bay at the top of the South Island. He is not an Amel specialist and I think

True we had our last meal ashore last night heading north now not sure where we’ll end up

Appreciate the update Stefan. I’ve postponed my flight this Saturday and we are now booked out of Montreal on April 4th. $170 One Way. Fingers crossed for getting supplies for the trek nord