|
Re: Leece -Neville Alternator external regulator install
Dan,
I'm planning to install the Wakespeed WS500 on Rascal. We have the Leece Neville 175A alternator and AGM batteries, and this regulator sounds like the way to go. May I ask how your install
Dan,
I'm planning to install the Wakespeed WS500 on Rascal. We have the Leece Neville 175A alternator and AGM batteries, and this regulator sounds like the way to go. May I ask how your install
|
By
Kevin Fox
·
#51693
·
|
|
Re: Membrane Tube end caps
Hi,
We have never put any chemical in even when leaving the boat even for up to two months. I think the fact that I am very careful to avoid using the water maker in dirty of contaminated water
Hi,
We have never put any chemical in even when leaving the boat even for up to two months. I think the fact that I am very careful to avoid using the water maker in dirty of contaminated water
|
By
Danny and Yvonne SIMMS
·
#51692
·
|
|
Re: Switch on Bilge Float Tube
Best of luck to you Diego. Hope to meet you sometime. Let us know how your switch install goes.
Ian & Margaret
S/V Loca Lola II
SM153
Bahamas
Best of luck to you Diego. Hope to meet you sometime. Let us know how your switch install goes.
Ian & Margaret
S/V Loca Lola II
SM153
Bahamas
|
By
Ian Townsend
·
#51691
·
|
|
Desalator USA
Desalator has an agent in Maine who is very helpful.
Contact Marc
58 Fore St. Bldg. 30
Portland ME 04101
USA Mobile: +207 522 6737Fax: 517 813 6509
Fair Winds
Eric
Amel Super Maramu #376
Desalator has an agent in Maine who is very helpful.
Contact Marc
58 Fore St. Bldg. 30
Portland ME 04101
USA Mobile: +207 522 6737Fax: 517 813 6509
Fair Winds
Eric
Amel Super Maramu #376
|
By
eric freedman
·
#51690
·
|
|
Pen Azen Membrane Tube end caps
Hi Amo,
As previously mentioned and originally invented by Ian and Judy on Pen Azen there is a very simple way to remove the end cap.
Just make a loop of webbing or dyneema and fasten it to the cap
Hi Amo,
As previously mentioned and originally invented by Ian and Judy on Pen Azen there is a very simple way to remove the end cap.
Just make a loop of webbing or dyneema and fasten it to the cap
|
By
eric freedman
·
#51689
·
|
|
Re: Membrane Tube end caps
Some years ago there was a post on this forum saying that Dessalator recommended flushing the membranes for storage just with product water, no chemicals. So I started doing that. I just replaced the
Some years ago there was a post on this forum saying that Dessalator recommended flushing the membranes for storage just with product water, no chemicals. So I started doing that. I just replaced the
|
By
David Wallace
·
#51688
·
|
|
Re: Membrane Tube end caps
You can buy Sodium Metabisulfite on Amazon or eBay. It’s used in beer brewing. Very inexpensive.
~~~⛵️~~~Matt
You can buy Sodium Metabisulfite on Amazon or eBay. It’s used in beer brewing. Very inexpensive.
~~~⛵️~~~Matt
|
By
Matt Salatino
·
#51687
·
|
|
Re: ZOOM Meeting of Members
#ZOOM
#poll
Hello Bill,
I would like to attend if it is possible.
thank you, Paul
Aramis
SM 444
San Francisco
Hello Bill,
I would like to attend if it is possible.
thank you, Paul
Aramis
SM 444
San Francisco
|
By
Paul Guenette
·
#51686
·
|
|
Re: Membrane Tube end caps
Hi Arnold;
I had placed an order for about 10 packs a few years ago. At the time they were 5 Euros per pack. I do see now that they have increased their price to 27.53 Euros on their website. That
Hi Arnold;
I had placed an order for about 10 packs a few years ago. At the time they were 5 Euros per pack. I do see now that they have increased their price to 27.53 Euros on their website. That
|
By
Mohammad Shirloo
·
#51685
·
|
|
Re: Membrane Tube end caps
Hi Mohammad and Atypisch,
wehre did you buy the sterilizing powder? My last bill from Desallator was € 22,95 +20% VAT for the powder!
Best and be save
Arnold
SY Zephyr
SM203
Am 22.04.2020 um 18:05
Hi Mohammad and Atypisch,
wehre did you buy the sterilizing powder? My last bill from Desallator was € 22,95 +20% VAT for the powder!
Best and be save
Arnold
SY Zephyr
SM203
Am 22.04.2020 um 18:05
|
By
Arnold Mente
·
#51684
·
|
|
Re: Membrane Tube end caps
We have followed Dessalator instructions for storage during the off season. We have used the reusable cartridge and powder provided by Dessalator. (5 Euros per use). We have not had any issues.
We have followed Dessalator instructions for storage during the off season. We have used the reusable cartridge and powder provided by Dessalator. (5 Euros per use). We have not had any issues.
|
By
Mohammad Shirloo
·
#51683
·
|
|
Re: Membrane Tube end caps
Paul,
I was referring to the fact that Dessalator recommends using the ST2 sterilizing cartridge and 1 packet of their "sterilizing" powder." This is regardless of the size.
Paul,
I was referring to the fact that Dessalator recommends using the ST2 sterilizing cartridge and 1 packet of their "sterilizing" powder." This is regardless of the size.
|
By
CW Bill Rouse
·
#51682
·
|
|
Re: Membrane Tube end caps
Before leaving the boat for an extended period of time I have always used 30ml Sodium Metabisulphite in 7.2l water (approx. 1 bucket), circulated through for half an hour, then allowing the bucket to
Before leaving the boat for an extended period of time I have always used 30ml Sodium Metabisulphite in 7.2l water (approx. 1 bucket), circulated through for half an hour, then allowing the bucket to
|
By
Paul Dowd and Sharon Brown
·
#51681
·
|
|
Re: Membrane Tube end caps
Matt,
We were never in cold climates
We were on the boat continuously with very few exceptions
I installed a 24-volt timer and solenoid valve to flush 2x weekly when we were off the boat for a month
Matt,
We were never in cold climates
We were on the boat continuously with very few exceptions
I installed a 24-volt timer and solenoid valve to flush 2x weekly when we were off the boat for a month
|
By
CW Bill Rouse
·
#51680
·
|
|
Re: Membrane Tube end caps
So what did you use, if you stored the boat?
I heard that propylene glycol (RV water system antifreeze) is a good substitute?......
~~~⛵️~~~Matt
So what did you use, if you stored the boat?
I heard that propylene glycol (RV water system antifreeze) is a good substitute?......
~~~⛵️~~~Matt
|
By
Matt Salatino
·
#51679
·
|
|
Re: Membrane Tube end caps
One of the things that have not been mentioned in this Topic is the possible causes of the deterioration of some materials used for endcaps.
There is anecdotal evidence that points to Sodium
One of the things that have not been mentioned in this Topic is the possible causes of the deterioration of some materials used for endcaps.
There is anecdotal evidence that points to Sodium
|
By
CW Bill Rouse
·
#51678
·
|
|
Re: Membrane Tube end caps
Hi Danny,
I fully agree we should not dismiss the choices Amel made too easy. I think the choice Amel made with the Desalator watermaker was excellent. But like with everything in life it was also a
Hi Danny,
I fully agree we should not dismiss the choices Amel made too easy. I think the choice Amel made with the Desalator watermaker was excellent. But like with everything in life it was also a
|
By
Arno Luijten
·
#51677
·
|
|
Re: ZOOM Meeting Technical Questions:
#ZOOM
Hi Tilo
I’m interested to join! Please put me on the list.
Regards from Zurich
Ruedi Waldispuehl
WASABI A54. #55
Von: "main@AmelYachtOwners.groups.io" <main@AmelYachtOwners.groups.io> on behalf
Hi Tilo
I’m interested to join! Please put me on the list.
Regards from Zurich
Ruedi Waldispuehl
WASABI A54. #55
Von: "main@AmelYachtOwners.groups.io" <main@AmelYachtOwners.groups.io> on behalf
|
By
Rudolf Waldispuehl
·
#51675
·
|
|
FW: [AmelYachtOwners] ZOOM Meeting of Members
#ZOOM
#poll
Hi Bill
I’m interested to join! Please put me on the list. These is a great idea, thanks.
Schedule is fine for me, Topics 2 and 6 are my favourites.
Sorry I’m probably a bit late because I was
Hi Bill
I’m interested to join! Please put me on the list. These is a great idea, thanks.
Schedule is fine for me, Topics 2 and 6 are my favourites.
Sorry I’m probably a bit late because I was
|
By
Rudolf Waldispuehl
·
#51674
·
|
|
Re: Switch on Bilge Float Tube
Hello Heinz,
Thank you very much for your interest into the IDN system.
Could you please send an e-mail to me at: diego.demiguel@... ? then I will reply your e-mail with more detailed info, technichal
Hello Heinz,
Thank you very much for your interest into the IDN system.
Could you please send an e-mail to me at: diego.demiguel@... ? then I will reply your e-mail with more detailed info, technichal
|
By
Diego de Miguel (Sailing Living Lab) Amel Sharki
·
#51673
·
|