*1* If the main break had tripped it is NOT a problem with the thermostat, look before changing it the heating resistance or if you have an insulation pb. *2* It had the same problem on the 3

This is a low speed bearing and I was assured by Amel that there was little chance of damage when it happened to me on route between Galapagos and Marquesas. Had the seal replaced several thousand

Dorades are not usefull, even in the Caribean where I am based.   With a  number of fans and opened hatches, it is confortable inside.   A bimini top over the cockpit is mandatory for

Our boat, SHAPIRIT, SM2000 #325 has apparently broken the prop-shaft seal and sea-water has entered the drive box, emulsifying with the gear oil. The boat is between Singapore and Phuket, and may need

Hi from germany, i just comming back from the med and had the chance to visit and check several Maramus and SM, santortin and even the new 54. You can find one or two them in every marina. What nobody

I have bought a replacement chain counter sensor from Pochon for my Super Maramu. It is the orange cylindrical type that fits into a black round housing on the port side of the Lofrans Tigres

I found the dealer for Quick in the USA QUICK USA LLC 21061 Glen Burnie, Maryland 509, McCormick Drive Contacts: PHILLIP SCOTT RHUDY Tel. +1.410.768.5991 Fax +1.410.768.5995 Toll-free

What would that be phonetically? <ornella.battaglini@...> wrote: as (which, stressed.) ---------- 10/11/2008 20.58

I am the new owner of SM 278 and preparing her for a maden cruise from Savannah Ga to the Bahamas this December returning to Charleston at the end of January. Last week I noted to problems with two

Please share your comments about purchasing and operating an older Euros. In your estimation is this vessel type, when properly equipt, suitable for long ocean crossings? Anything you can share

Dave Can I ask are you talking about the mainsheet traveller?If so our original ia adjusted with locking stops either side of the car and does not have control lines Deb Orion1 Maramu

Greetings, On our Maramu (#29) the previous owner retrofitted a Harken traveller on top of the existing Goiot track. He reused some of the original fittings to create standoffs of sorts but the

Bob the correct frech pronunciation of Santorin is Santorèn Ornella Santorin 122 Earendil

Hi, given that the holes are that big I'd do the same... I am not a big fan of using different metals together. And max strength is not at at issue here so long as we do a good job with the rope

HI, given that the you have an aluminium element you should use an aluminium rivet. If you can take the SS set screws out and replace them with the rivets. You'll do better with this solution over

Located in San Francisco Bay area. Website here: http://homepage.mac.com/northp/sharki/sharki4sale.html or see at sfbay.craigslist.org under boats.

Hi David, Sorry, but the French reserve the correct pronounciation of "Santorin" strictly to themselves! Cheers, Craig

Contact Bill Hansen at Navimo,USA, 7455 16th Street East, Sarasota, FL 34243, tel: 941-360-1888, ext 111,  whansen@... for Goiot parts and gaskets. Anything they don't have in stock, he

Richard, I was told that the monel rivets would not be a problem with aluminum and would be stronger.Do you agree with that .I will probably leave the s.s set screws in, because the holes were drilled

Hello, I'm interested in a project boat in NY. It's a '71 Amel Euros. Do any of you know this boat? Whether you have or not, I am interested in any comments on what I should know or look out