I have an Amel Super Maramu 2000, hull 323, built in 2002 to 2003 specs. The a/c in the salon (only) leaks condensate, which eventually enters the floor compartments in front of and under the sink,

Yes, message 'tags' would be great. I'll check with Yahoo on this. Richard wrote:

Hi Richard The Boat locator feature was nice! Hope more Amel owners will sign up there. Could it be possible to get different sub-titels like "sails", "electrical", "navigation", "anchors", and so on

Located in Trinidad (on the hard for 9 years). See on ebay or email sailingbebe@...

Hello Richard, Well that worked perfectly. Lots of work but produced results. Thank you very much. Bill Rahmig

The Onan MDKV has what I call a "computer start" sequence...Press the start button and a few clicks and buzzes later, if the computer likes what it senses, the starter motor will engage on the diesel

If anyone has a list of various capacitors used for electric motors and compressors on a Super Maramu 2000, please post any or all on this site. They can be purchased in an electronics shop for a few

Great information. Thanks a lot John and Anne I will check the capacitors and fuses and buy some spares to keep. My own experience paying people to work on my previous Beneteau 361 told me that

I agree with Anne and John, SM319 message : DO NOT FORGET that you must us the thermal protection fuse it is very important (a bi-metatl can failed). Normaly the old is ok (new cost

Electric fan heaters have, or should have, a thermal cutout/fuse to disconnect the power if the element is over heating. This is in addition to the thermostat. I have a free standing fan heater

Hello everyone, Yahoo has and continues to roll out a lot of enhancements that'll give us even more flexibility and capability. Already you may have noticed that that Photo section storage increased

Gary and Mary Silver, I concure with your summary and wish to add the windscoop I am installing at anchrages and only need little rigging.    

I forgot to give you the value of the temperature regulation of the bi-metal, I have calculate it but results are on my boat .. and I go on it only in December, sorrry... Other important point : if

Hi! I am purchasing a 1970 Euros. It needs a lot of work. The result should be well worth it, however. If there is anything you can tell me about the Euros, anything to look for, your experience

Hi, when trying to change the head stay or the bolt you need to do the following; 1- back off on the back stays at the Mizzen 2- back off on the back stay for the main mast that is in the cockpit 3-

Ian, I used a small steel pin to drive if it will not come out easy. Remove the counter (2 small screws) and the wires keeping a note of the colored connections. Now with a 2 pair of channel locks

Hello, I am trying to replace the forestay 3/4" SS bolt with a new one and can not get the forestay loose enough to remove the old bolt. I have unwound the lower toggle about 2 inches and applied a

Hello: I have an Amel Super Maramu 2000 (hull # 335) and have been cruising it for the last 7 years in the Caribbean with one season along the mid-north coast of the USA as far north as Baltimore

What kind (make, model, # of burners) of propane stove did Amel install as standard equipment in the 1970's?

Merci beaucoup monsieru Mertz. 1) I agree that the thermostat is probably not the culprate and am planning to check the heating element and the cables leading to it. 2) Good point about the