Hi Anne and John: What you are describing is dye penetrant testing and is a standard type of NDT (non-desctructive testing) for cracks in metals. For a quick description see

Hello Niels and all, At the risk of overkill, I am re-sending a posting I made a few years ago on the subject of turbos: Volvo TMD 22 Turbo: Lessons Learned During the past summer, I learned a

Who's friends with who and co-starred in what? http://www.searchgamesbox.com/celebrityseparation.shtml

Many years ago I read that a good way to crack test rigging terminals is to apply a fluid which shows up any cracks but I have never heard or seen anything of this majic fluid since until now when I

<<<<<The following email is from WASI>>>>>>>>>>>>> ……. It should take 2 people not much more than 15 minutes and will have absolutely NO negative effects on the structural integrity of the

To wipe off the wood work and take any cooking grease or hand prints off we use a soft cloth with about a 10% vinigar mix. It does not hurt the finish and cuts the grease... Richard SM 209 in

--- Wanted to purchase : Santorin in the U.S.

I am in the market for a Santorin that I would like to purchase within the next 4 months. Please contact me ai gmcerillo@... or 757 348 5667. thank you George

Great - thanks Bill wrote: wrote: rail. I few

George, The original Santorin brochure gives "Tirant d'air" as 17.5 meters (or 57.4 feet). Add 3-ish for antennae and call it 60 feet. We've done ICW just fine, but, as noted by others, watch the

John, In BeBe #387 it is 37 1/2" Bill Rouse s/v BeBe SM2 #387

Ian: Best access is to pull the fridge out. It is very simple. From the centerline locker at the bottom of the companionway steps, reach underneath the floor panels towards the port side panel in

Pen Azen again. We have had recent problems both with our Simrad vhf and Icom IC M710 SSB, both to do with power output. The Icom agent here in Rio replaced a transistor ( 2SC 4673) in the SSB . It

Peter, use 3M 5200 ,sand the rubber lightly apply the sealant, let sit for a week. If that doesn´nt work,Throw the thing away. I had my Zodiac professionally glued at a cost of $600.00 it lasted 1

Pen Azen is an SM 2000, no 302. Our fridge needs some gas added. The two valves can be seen either by looking from inside the adjacent locker or by taking off the wooden panel underneath the fridge.

Could somebody post the length of the leather wrap on the grab rail. I need to order a new one and I can't get down to the boat for a few weeks. Thanks John Abercombie SM 394

<annejohn@...> wrote: lack YOU couldn't shut cause in good <nrfaerch@> is developing max be cooled/cleansed with > oil rather than leaving the burnt oil to dry in place. It also > recommends injecting

wrote: wrote: HI, most likely the due to lack of use the turbo charge is stuck. Pull off hose and clean with something like CRC 5-56 to free it up. To stop it from

wrote: Hello Peter, It will not be Hypalon as Zodiac does not use that material. I have had a lok on the web and the best I can come up with is " service@..." They actually advertise

Hi, We took a Santorin up and down the ICW around 5 years ago without problems. You cannot go south of Lauderdale as there is a "low" bridge between Lauderdale and Miami. After the Deleware