23 June 2006 Dear Yves: Thank you for more details on your system and on the type of near fire that you suffered. Your description has led me to do some additional research on my watermaker. Does

Eric: The first posting was of my actual measurements of the old O-rings as removed. I measured these with a digital micrometer. I then took the used O-rings to HydraPak and asked them for matching

Hi, Please remove our e-mail: hallelujah_mk@... from your group e-mail list. Thank you Kim

Hi Ian and judy I enjoyed reading your message on drinking water produced on board. I have my “ judy ” on board, her name is Marie-Christine, but I never had the idea of making a blind

Hi Ian, I am very glad with your last post on this forum. As to the letter to send to J.J. Lemonnier, I am about to write it. Did you send it as registered mail? I quite agree that this

Dear Gary Sorry for answering late, but I am not so often near an internet I confirm that I nearly had fire in my boat due to Dessalator 220 V. motor by end 2005. My equipment is a Duo 220 V. / 24

Gary, You made 2 postings of the "o" ring measurements which measurements are correct? Is there a problem with using silicone on the "o" rings in the same area as the membranes? Thanks Fair

Could anyone advise as to the number and size, (expressed as a percent of J), of the jibs on the 54? Best Regards, Anne and John Annie M

21 Jun 2006 Eric: I purchased my 0-rings from a local vendor here in Salt Lake City, Utah, USA, called Hydra Pak 1-801-973-7325 . Any local supplier of O-rings should have these O-rings since they

Gary, We have a photo of our circuit board. Not sure if it will really help you or not. Please provide me your email address offlist at sailingjudy "at" gmail.com as I could not find an email

amelyachtowners@... Problem with ONAN generator Dear Patrick (Caramel), I read on this forum that you had troubles with starting the ONAN group. I hope you solved the problem. Me

Thanks, Gary. I think my green light takes much more than 55 secs before it lights up, but I am off the boat until October and will have to check then.What I do have is a small tap incorporated into

Gary, Thanks. Where did you get the "o" rings" ? Fair Winds, Eric Amel Super Maramu #376 Kimberlite _____ From:

Eric: Did you see my previous post on the details of repairing the membranes including where I purchased the membranes? In my view it would be virtually impossible to replace the membranes without

Hi Eric, Sorry to hear about your water maker problems. I recently had to remove my membranes to replace a split end cap on my 160 l/h unit. I found that the easiest way was to drop the whole cradle

Gary: Did you get these O-rings in the US or order them from Amel or Dessalator? Mark Pitt and they are as follows

Hi Gary, Thanks for all of your help. I took the boat for a spin today and ran the watermaker for about 5 minutes before taking a sample of the water directly from the watermaker membrane after

Hi Gary, We will try to take a photo of the circuit board tomorrow or the next day. The boat has been in BVI almost her entire life, in Grenada now. Sorry, cannot tell you the proportions of the

18 June 2006 I located my receipt for the O-rings I purchased for the watermaker and they are as follows 9.0 by 1.5 mm N70 19.0 by 2.5 mm N70 53.0 X 3.5 mm N70 N70 = Nitrile (Buna)

18 June 2006 Judy: Thanks for your response. Any chance you could take a digital photo of your control circuit board (located in the electrical box on the back side of the control panel, accessed