Hi, do you have the specifications or make and model number of the capacitors? I had the same problem and would like to have a spare other than from calpeda. thanks Eric Amel Super Maramu #376

Hi Dave: Regarding: "What is the expected life of the Clima AC components, if they are used regularly in the tropics." My boat was delivered July 1, 2001 and the ACs are all going strong. We use

Hi Gianni: I am not sure why I can't get your emails. I configured my email to accept your specific email address. I too have never had that happen before. I made 10 more tools tonight and will

I replaced the impeller assembly on the ac pump. it was a simple job. that is what usually needs replacement as ling as the motor is turning. Fair Winds, Eric Amel Super Maramu #376 Kimberlite

Hi Gary, sorry I receive all your em , but I receive back my answer to you, also the last one with TEST COMPLETE I have never had such a problem !?!? Gianni

I echo Ian and Judy's response. I recently had the original Onan water pump rebuilt (1300+ hours on it!) and ordered a new pump also. The old/original pump was chewing up impellas. Pulling the pump

On SM #230, 1998,I recently had the air-conditioning system checked out, and there were concerns about the ac water pump leaking. Has anyone either rebuilt or replaced the AC water pump. What is

Hi Mike. I would suggest that you also think about all new bearings along with your seals. Salt water has done them NO GOOD.... I would also take a very close look at the transmission case. If you

Hello Group, Here is a question for you. has anyone experienced the oil in the transmission (15W40) appearing like milkshake? most probably caused by sea water leaking into it. While motoring near

Hi Gary, yes please send me more detailed photos. $ 100 shipping is too much ! Still problem with your mail box service provider. About antifouling for prop blades I use and I 'm very happy now

Yahoo was notified that the Search function was not working properly. Below is their response. If any of you are not able to conduct a search (or use any other feature such as posting a photo,

Hi Charlie: Thanks for your reply and to the others who chimed in with their service experience. I don't have any vibration or noise, but I noted during the last haul out, rusty colored water emerge

Hello to all those who have requested impeller pullers, including Giovanni. We are ramping up the production line tomorrow (Oct 1) [it isn't a very big production line as we only make 10 at a time]

Gary, Based on the symptoms you have noticed I agree that bearing replacement is a good idea. Certainly any sign of water from the grease holes is cause for concern. I do not allow pressure

I have about 2200 hours on mine and it is fine. Fair Winds, Eric Amel Super Maramu #376 Kimberlite _____ From: amelyachtowners@... [mailto:amelyachtowners@...]

Dan, I don't have a Webasto, but I installed a Wallas diesel heater. It was the simplest one I could find as I didn't want to run any ducts throughout the boat and I only wanted to heat the main

There is an alternative, really simple, means of accessing the Onan impeller. 1. Simply disconnect the two water pipes ( by loosening the two jubilee clips and pulling the pipes off the pump) 2. Undo

Photo attached. The davits are, from memory rated at 250kg+. Our dinghy weighs 32kg and the outboard the same so all up no more than 75kg which gives a lot of spare capacity. Given this, we notice

Hi Gary, sorry again ,I cannot contact you at this addres AgCEagle@.... Can you contact me, please, at gtesta23@... ? Thanks to the next, Gianni wrote: 3273 wrote:

I'm at 2300 hrs and all is well. Rob of Nebo SM251 From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of svmalaika@... Sent: Saturday, 29 September 2007