Hi Diego de Miguel Sharki is a very good choice. Here is the user manual in French. Welcome to the Amel family Dominique Cigale Shaki #125

Hello sailing mates! I bought an Amel Sharki (nº 58 - 1982) recently. At present I am workring into the boat set up... A lot of work to do! :-) I am using this boat as my home and also for my

it makes some sense as this is the alternative flash water supply for the bow head.

Yes, 184-00-076 is the sensor used on the SM and 54. These originally were around 1,000. Bill

Thanks all for your replies. I did notice there are two models for the sensors. I have difficulties understanding how the straight one would sit in the hull given it’s position. At present it’s

Mike, Yes, but I knew that Cloudstreet was a SM2k, have been aboard her, and knew where to point him. During the production of the SM, the location of the anchor wash pump changed from the bow to the

Not all SM’s are the same, as we all know. On ours, the anchor wash breaker is in the V-berth on the port side, fairly far forward, a white box with an icon of waves on it. Tom Peacock SM #240

Bill, The following photo is from the A-54 Manual, but the breaker box is similar to the one on your SM inside the engine room on the bulkhead. Note the red circle. The anchor wash breaker is "EAU

Breaker is on the breaker box inside the engine room. Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550

Hi Arno, Alan, Mohammad, I purchased my Amel 54 in 2013, she is on of the last production year from summer 2010. in 2015 the Sonic Speed System showed more and more failures (typical way of coming to

Hi Arno, If a 54 indeed has the straight type like my 53, that is B&G part number 184-00-076/FI Bought a pair( replaced & working) in August 2019

Hi Arno, If a 54 indeed has the straight type like my 53, that is B&G part number 184-00-076/FI Bought a pair ( replaced & working) in August 2019

The anchor wash switch is powered up all the time with everything turned off. Not good. Nothing in the Amel wiring schematics show the wiring . Anyone know where to interrupt the voltage with a

Hi Arno; Unfortunately, its been 5 years since I had the last look. The timing of this season is currently unknown, but the next time I’m on the boat, I can check it out and get you some

H Arno, They are small cylinders with the cable coming straight out the back, but they are not available anymore. When ours failed we left them in and installed a thru hull Airmar CS4500 near the

Thanks Mohammad, Do you know what shape they have? Are the cables connected at an angle to the sensor? Regards, Arno

Hi Arno, When we initially purchased Kokomo, we were told that sometimes these speed sensors go out and it is not made any more. The broker had an extra one that he sold to us. That was 5 years ago

Hi Forum, Has anyone actually seen the model of the transducer used for the speed sensor (B&G Sonic Speed) used in several A54's? These are the solid-state sensors in the leading edge of the keel and

Hey Oliver, no sweat. It's a bit more than a tweak, but you'll never get a bed as nice in any other boat, esp for a very tall person. If you do end up getting an Amel, I'll tear the cabin down and

Hi Bill I just looked at the link for Island Pearl II and it goes to the SV Sabbatical Blog. Please swap that link to this one: https://forecast.predictwind.com/tracking/display/IslandPearl2 which