What I didn’t make clear in previous text was that the 3x12.00$ pump relays effectively replaces the expensive and unreliable frigoboat pump controller. So a good, reliable and inexpensive option to

Hi Scott Thanks again for the tips. The alternator will be my next step after some local testing yes. We are away from the boat down in Sydney for a week, but the Lithium install went perfectly on

This is great information and a good leg up Thank you very much Paul, Danny and Bill

Stuart. Is the pressure good after pumping up the tank? If so, it sounds to me like the next thing to check is the pressure switch. If it is adjusted incorrectly the pump will keep running as it is

Same experience. Worked for a short while making me happy & proud and then quitting on me. Endless story. Best Regards Teun SV AMELIT A54 #128 Currently on the hard @ THE BOAT WORKS YARD

Hi Kent, I have 4 SENA units on board since 1 year; only used 2 or 3 of them. They work fine – no issues necessitating warranty claim. Sure beats yelling from cockpit to stern or bow. Best

Karen , Maud sent me a drawing of the cross section ,but just looked at it, and its too crude ,not to scale. Perhaps if you pulled up the end of yours a couple inches and take a photo. If someone had

Hi Mark, Pending pricing detail confirmation, we are very interested in the possibility of joining the rub rail order and shipment to the US East Coast! Has anyone researched having a custom

Hi Craig, I'm currently attempting to remove and replace the bearings in the lower c drive however I'm having trouble getting the 'trumpet' off. I have the same c drive as you and have removed the

Hi Aty and Mohammad, I would recommend talking to Alex Ramseyer about his setup with an Highfield. It is long enough that he can fit it very securely under the Simpsons davits with the outboard on. I

Hi Charles! It will be approx 1.5 x 1.0 x 0.8 meter and the weight about 100kg. My sister she is living in Charlotte, so I could ask her to pic up the stuff in your place. Our plan is, to sail up

Charles, If you end up doing this shipment, I would like to add a stern bumper as well,probably could fit nicely between the inside of the rolled up inserts. Thanks, Pat SM Shenanigans

Dear All: I wasn't able to locate my waybill with a weight, but the invoice from Maud was as follows: 32 metres 3459 Liston De Coque Ivoire SM Ref P 000470 / Ivory Rubber scupper Material for Super

Welcome aboard Eric! OK, we have Charles (me), Patrick, Mark. and Eric. We will continue waiting a couple of days to see who else wants to join. Is anyone else jumping in? Charles SV Jupiter Mango

I would be interested for the inserts for my Sm200 #376. Fair Wind,Eric Kimberlite

Hi Mark, After 16 years I had the bottom of Kimberlite cleaned down to the gelcoat. I did not want to use any form of blasting. I had the yard use a chemical stripper available at Home depot to remove

We started out with Eartecs. They work at a different frequency, and actually found the sound quality and range a bit better than Sena. But ours were older, and had a belt pack connected to the

Hello Stefan, I was planning to bring the container into Annapolis, MD or the port of Baltimore. I have a location to receive the shipment, breakbulk, and reship or allow pickup. Do you know the

Sorry, Stuart. Pumping up the tank fixed the problem of continuous running for me. Stupid question, sorry: Do you have water in the tank? Cheers. Joerg

Kent, it sounds like the Sena is a better option then. I never looked at Sena when I bought my Eartec since I had experience with them before and my friend had used them for over a year without a