Hello everybody, I'm owner of An Euros with a cockpit remade in teak. Unfortunately the installation was poor or the deck is very old (or both...). In any case, I need to replace it. I'm not very fond

Hello all, We set sail from Grenada bound for Boniare. We set the poles and both head sails. The first 24 hours showed 202nm on the GPS over the bottom and the second day clocked 199nm over the

Does anyone know who manufactured the seacocks used on the 1984 Amel Sharki? I need to replace a handle and cannot identify the mfr. Thanks for any input.

Dave, We would use the Shadetree Awnings more often if: 1.) We were at one place for longer than a week or two. 2.) And if we did not have a custom extended bimini with shade panels on the sides and

Hi Judy; I'm wondering why you decided not to use the Shade Tree, and am also wondering what you have rigged up as an alternative. I have found that once the shade tree is rigged up, it works well.

Graham, try turning the handle the other way to roll up the sail. That way the screw is always getting tighter. It should run out easy. Good luck and fair winds. Richard SM 209\ --- Graham

Gary, We have a set of 3 Shade Tree Awnings that have barely been used, if you are interested in purchasing a set. We are in Isla Margarita and will be in Bonaire approximately August 1st. We

Dear Dave, Thank you very much for the information-I have looked at there web site and have start a dialog with them. The awnings look like they will provide great protection and assume that they will

I recently a 53 SM 1998. The previous owner used a canopy produced by "Shade Tree" [http://www.intheshd.com/]. It comes in 3 sections to cover the entire boat. Some of the sections and tent pole

Hi Dear All When I tried to furl the mizen sail into the mast using a winch handle in the hole on the front of the mizen mast, after a few turns the sail would no longer furl and the winch handle

Bill & Judy, We did purchase a Sharp R-228H Microwave Oven on-line at http://www.western-international.com. The price and shipping were very reasonable. It is smaller than the original, white which

Our vessel is presently moored in Spanish Waters,Curacao and will be there thru November/December. We would like to have a canopy made to cover the vessel and us from the hot sun. Plus it would help

Diane, Our "repaired" microwave failed again. We had Caroline at Amel in Guadeloupe purchase the same microwave that Gary describes below. She is holding it until we arrive in Bonaire and will ship

According to the Racor information supplied with the adapters, the rubber spacer is required for those units which have a "flat top surface" on the cross bar at the base of the standpipe.

Thanks for the Racor filter information. Our dual Racor was installed by AMEL in 2005, but I am not sure when it was built. The brown 2 micron filters we use do not appear to go down below the

We found some information on the adapter...here it is: Racor 500 Series Built about 1996 or 1997 and before may need a Spacer if using the new Racor element 2010 S T or P. This Filter can be easy

We recently purchased a new supply of Racor filters and noticed that the color of the plastic on the Racor brand 2 micron filter was now beige/brown, whereas the previous Racor brand 2 micron filter

Our SM is no 302, launched in June 2000.I need another chart chip for the Geonav plotter but I am in London and the boat is in Uruguay.Some of the new Navionics cahrt chips use an updated software and

Hi, I was owner of "Kavanga" (# 69, sloop)for 10 years. We had the motorlight on top of the mast and the switch was on top of the front door leading from the saloon to the bathroom, next to the switch

My Santorin, 004, was not fitted with a "motoring" light. I understand that for some reason Amel would not fit them. I had to put on a bi-colour on the pulpit and a steaming light on the mast!