though metal Service. used cars

Gary, Thanks for the info. Where is your boat now? We are in St Martin. Fair Winds, Eric

Eric: I purchased 3/8 inch quick connect fittings at Home Depot (white plastic, push together fitting that are good to 100 psi) and cut the blue 10 mm product water line. There is virtually no

AMEL Owners Group: Further to my last posting regarding the 28 volt replacement lamp for the foredeck light and the mizzen mounted cockpit light, G. E. makes both a spot lamp (clear, non-fluted

Gary, How did you hook the salinity sensor into the watermaker output? Fair Winds, Eric Amel Super Maramu #376 Kimberlite

Hi all I know many of you have added Racor fuel filter systems to your Super Maramus, and I am wondering which models you have found to be a good fit for the Amel. Our SM is a 95, with the Perkins

Hello, Can you please send some photos and info? My mail address is jose.luis.isasi@... Thanks. JL <syhanaleism@...> wrote:

Amel Kirk, Year 1978, No. 229, one Swiss owner, sailed on Lake of Constance, Teak deck, many extras, EU 35'000.--; please ask for the documentation.

I had to replace the stop cock on the forward holding tank as the old one seized up. The local chandlery sold replacements..in bronze as the original for about US$10 or in stainless for $50. It was

Bob, I ordered new valves myself because the old ones are a little hard to turn off and on. The fiberglass around the valves on the holding tanks seem to be more decorative then anything. Its above

I have a spare brand new (hoisted a couple of times but not used) Super Maramu Ballooner for sale. I'll sell for $1,200 plus actual UPS or Fedex shipping cost (only to US or Canada address,

Amel recommends replacing or rebuilding the "sea water valves" in their maintenance schedule. In their owners manual they refer to these as "stop cocks". I obtained replacement stop cock valves for

I had similar trouble with my 160 l/hr watermater on SM # 335. This behavior began about 6 months after it was new (about the time we set off across the Atlantic). The 20 amp breaker would trip

Hello fellow members, We are the new owners of SM266. Question, I run the generator (we are on the hook in the BVI) and the green light comes on, on the 220V panel. I deperess the breaker to turn on

Joe, Craig's advice is spot on, we follow the same approach. I use a relatively inexpensive (~$80) magnifying loupe to inspect the fittings -- you need somehting like that to be able to see a very

Joe, Robin's repy points out quite clearly the "mysticism" of rigging lifespan. Too many factors impinge - many years in the tropics - bad; many heavy weather sails - bad; a berth with a "jerky" chop

15 Feb 2006 Hi all: I just completed installation of new FilmTec SW30-2540 membranes ($177.00 each from Air, Water, and Ice, Inc.) in my water maker. Not a difficult job one accomplished.

The answer to my earlier question is that 1/2 cm of movement is entirely normal. Ian Jenkins, Pen Azen,Santos, Brazil.

thank you amelliahona <no_reply@...> wrote: --- In amelyachtowners@..., "pjppappas" <pjppappas@...> wrote: vollt, 50 watt). There are also surely direct replacements (size,

Frankly I would talk to your insurance company - some will not cover rigging failure after 10 years unless it has been tested, others don't mind. For peace of mind we replaced ours after 14 years