Hi James, 1. If the boat is ashore I would check that the shaft is true. You would need to pull it and take it to a machine shop. 2. I would check the engine alignment again. It is not easy to get

HI, The attached photo is of the stuffing box and where the shaft on my maramu exits the boat. Is the circled part another bearing that is glassed into the hull? We have a "sqeak" or hum when the

I guess I should have just sent you the links.😀 Best, CW Bill Rouse Amel Owners Yacht School - www.AmelOwnersYachtSchool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Thanks for the follow up Bill, I did read about Scott on Tengh rewiring with 2x50mm2 for his 5000w inverter. I believe others have installed the 3000w with the 100A wire. Can't recall the size

Pat, The potential grease port location I spoke of may be easy to reach on one rack, but I am not sure about the other. See below. --

Pat, I haven't considered that. I assume that you are referring to the racks...the steering cable is sealed. I assume that the "leaking grease" is coming from the rack housing at one end or the other.

Hello, We have a similar issue with our VHF and haven't so far figured out if due to antenna or cabling. (measure of the impedance between the core and shield of the existing system returns a infinite

Bill, For some years now I have had a minor leak of grease from the rack&pinion . What do you think about adding a nipple to put a little grease back into the unit . Thanks, Pat SM Shenanigans

- the TF Marine pump is identical to the amfa reya marina zz? Very close with some subtle differences--- and all of the rebuild parts are identical. - the maintenance kit provided by amel is a TF

Dan, Yes, the Amels that I have seen have increased the size of the wiring. You might want to look at

Dear Amelians Just wanted to confirm my understanding after reading this thread - the TF Marine pump is identical to the amfa reya marina zz? - the maintenance kit provided by amel is a TF marine or

Hi Bill, yes I'm well aware of the different cable sizing standards. But was looking for the reference data for the actual cables in the SM. The existing cables are well shielded and have shrink

Actually I am not on the boat for measuring. -- Gerhard Mueller Amel Sharki #60 Currently Kalamata, Greece

Thank you. Bill... Kindest regards Arthur Skickat från min iPhone

As others have noted, good descriptions in our Group. Also.... http://www.oceannavigator.com/March-April-2011/Prepare-for-survival-conditions/ Bob,KAIMI SM429

The cables are sealed. The racks and pinion have to be disassembled to add grease. Best, CW Bill Rouse Amel Owners Yacht School - www.AmelOwnersYachtSchool.com 720 Winnie St Galveston Island, TX

Thank you for your reply Ann-Sofie, The ones I saw at sailrite were all either 22mm hole to hole or just under 16mm. I'll take another look. All the best, Paul Stascavage SM #466 - s/v Rita

Hey Paul - Can't help you with the fasteners, but if you're exploring Brunswick, GA this is an absolute must visit." A short walk from the marina. Cheers, Craig

Thank you Gerhard. From the description I am not sure if the overall length is 22mm or if the hole to hole dimension is 22mm. Have you purchased this item or can you verify that the hole to hole

How and where do I Grease the Steering Cables? arthur sundqvist sm435. Vista Fair winds.....