Hi everyone, my model is original Maramu Hull #105 - not sure it will fit a Sharki. Yes - they can tint the acrylic (windshield) if needed and the polycarbonate (hatches and portholes). lmk and I can

Hi, I am using Yachticon Aqua Clean since 20 years! Never had any problem!! Once I also stay in winter in Sicily and there is no freezing problem, put it inside,fill the tank, be happy😎 SY

Also, you can flush with Sodium Metabisulfite, used for pickling watermakers. It must be flushed out of the system in the spring, and used with an RV antifreeze if you are in a freezing

You can use Hydrogen Peroxide. It converts to water over a short time. ~~~⛵️~~~Matt

I also have about 6 small (2mm dia) holes that are right through one of our baby poles. All these are within about 50cm, but are not located in the vicinity of the pole attachments. It looks like

Hi Ruedi There is no need to clean the water tank if you keep it filled if you leave the boat for the winter. The water will not go bad for such a short time, and keeping it filled makes it more or

Dear Amel Group, hi Stefan After having a wonderful season we are now cleaning and make WASABI ready for the winter. I have followed the tread about cleaningthe water tank compartments last

Wow- thanks Alan; Maud told me just now the ends are available but it didn't occur to me that there might be different SM pole configurations. Tom and Kirstin SM2K 422

Kirstin just completed our new bimini- she kept the frame bars the same length but moved the forward bar 4 inches higher in the channel. The result is a zip down window (40 gauge stratoglass) above

Hi Paul! I'm looking for a Bimini exactly like you did. Could you tell me where did you made it? If you have more details, I'll appreciate. Jose Prieto SY Wayag SM323

Hi J-P, I noticed that your poles are quite different to ours...not surprising SM007 cf SM437 Ours, as probably SM422 are quite a lot bigger in diamtre and the end fittings are quite different. We had

Hi Jer, I have had an unfortunate mishap resulting in my starboard wind shield being neatly broken in two. So I am interested in getting a replacement, which Amel do not have. One possible

Hi Tom and Kristin, I broke one of my baby poles on Pacific passage and lost the end fitting overboard. I used the other one as a model and had a copy made in NZ. The pole itself is available at any

As I mentioned in an earlier post, a large bulging crack emerged from under the black collar on my inner down wind pole. My welder confirmed that the inner end sleeves are corroded and burst through

Thx to all of you for the experiences and good hints! We also tried it with a blanket and the noodles. Now we continue with learning to ignore the noises. In the last 5 days I already realized some

Arnold I have no experience with an auto prop. I don’t know if it folds up if you leave the throttle lever in neutral. For the prop shaft alternator to work you must: Switch off the engine and take

Hello All, yes, my boat having the shaft alternator and I am happy that I posted the question...otherwise I would have overlooked this matter that the folding prob may be counterproductive. I am

Hi Kent, hi Iris, many thanks for the welcome note! Volker SY Aquamarine Santorin 027 Malaysia

Miles, Viewed from the engine room, on my Maramu there is a copper strip that starts at the forward engine room bulkhead that runs aft down the inside of the Port engine stringer and then

Hello Amelians I’m going to attempt to redo my bilge bonding strap connection as part of this winters growing list Thanks to this forum for excellent tips and tricks on this project so far. In