Yes this is HP from Tamango 2 I got the chance to order the last piece of Steering material, racks and pinion from SAV. I told that to Bill and SAV will look for new mybe new sources. But; my

Arno, Yes Best, CW Bill Rouse Amel Yacht Owners School - www.AmelYachtOwnersSchool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Hi Bill, I may have missed the answer to this question but is this rack/cables also for the 54? Regards, Arno SVLuna, A54-121

James , That seems like a good idea , I will begin to fix it off center. I was wondering if the rack could be rehabbed ,is the rack cast metal or could metal be welded and teeth fashioned . Pat SM

Bill, That is interesting speculation about the smoothness of an autopilot affecting the life expectancy of the steering rack and makes sense to me. I have also been concerned about the possible

I realize that I was probably too conservative when I stated that "the steering rack normally lasts 20+ years." I think with very few exceptions, the rack has lasted closer to 30 years, than 20 years.

I am not sure, but I believe there is a good chance they are the same. check with SAV"at"Amel.fr --

Sav@... have a smaller inner diameter ring to fit that new motor. I posted info on it some time ago Alan Elyse SM437

Dear Bill, Are these cables the same as those used in an Amel Mango? Best regards, Rob Dillmann Westwind Mango 43 Verstuurd vanaf mijn iPhone

Bill, Understood. Thanks, Mark -- Mark McGovern SM #440 Cara Deale, MD USA

Thank you for doing this leg work Bill. My steering functions, feels, and sounds fine. Kristy is 19 years old and we are embarking on a planned Caribbean, S Pacific and Mediterranean cruise in a few

Mark, I believe that the US distributor probably misstated what Ultraflex is doing, but since I am not speaking directly to Ultraflex, I cannot know for sure. Since Thierry BILLARD, manager of SAV at

Hi Tom, I had new mounting discs made from 3/4” delrin by a machinist. They were about $125 US each plus material. I had to buy a 1 ft square of 3/4” delrin. Kent SM 243 Kristy My old furler

Bill, Just to clarify, Ultraflex is committing to make one last batch of cables ONLY? What about the rack and pinion gears? From reading posts on steering failures on this forum it seems that the

My old furler motor (original) called it quits. While It will be rebuilt, tested, and become a spare, my spare furling motor (bought from Amel years ago) is slightly different in that the old motor's

Hello to the group, I crossed the atlantic via Cape Verde to Martinique this year, sailed up to Boston and now to Fort Lauderdale. I plan to sail back to europe in April 2020. If an Amel owner would

Thanks Bill for your service Best Elja Von meinem iPhone gesendet

That bolt stabilizes the C-Drive from torque. Below is a snip from my Amel Book, showing the bolt and its rubber bushing. It should be sealed with a flexible removable sealer. Black silicone RTV is

All SN, SM & 54 owners: If you recall, one owner attempted to order steering rack and/or cable parts from Amel and was told the parts were no longer available. As soon as I read this, I got in touch

There is a keel bolt near the C drive that is covered in a thick black rubber sealant. The sealant does not appear to be silicone based. I have a tear in that black rubber cover, revealing the head