|
Volvo D3 110i-A raw water pump and damper
Regarding replacing the Raw water pump Volvo 21141637
It looks like there is also the option of the Johnson pump VP0030DA as a replacement that is about half the price of the Volvo one. Thanks for
Regarding replacing the Raw water pump Volvo 21141637
It looks like there is also the option of the Johnson pump VP0030DA as a replacement that is about half the price of the Volvo one. Thanks for
|
By
ngtnewington Newington
·
#49160
·
|
|
wiring of the genset fan
---------- Original Message ----------
From: eric <kimberlite@...>
To: Amel Owners <main@amelyachtowners.groups.io>
Date: November 11, 2019 at 10:13 PM
Subject: wiring of the genset fan
---------- Original Message ----------
From: eric <kimberlite@...>
To: Amel Owners <main@amelyachtowners.groups.io>
Date: November 11, 2019 at 10:13 PM
Subject: wiring of the genset fan
|
By
eric freedman
·
#49159
·
|
|
Re: wiring of the genset fan
On November 11, 2019 at 10:13 PM eric <kimberlite@...> wrote:
Bill,
The Load (the fan ) is connected to the to the capacitor as well as the brown wire both being in parallel are then connected
On November 11, 2019 at 10:13 PM eric <kimberlite@...> wrote:
Bill,
The Load (the fan ) is connected to the to the capacitor as well as the brown wire both being in parallel are then connected
|
By
eric freedman
·
#49158
·
|
|
wiring of the genset fan
Bill,
The Load (the fan ) is connected to the to the capacitor as well as the brown wire both being in parallel are then connected to the other side of the fuse.
The black wire is hooked up to the
Bill,
The Load (the fan ) is connected to the to the capacitor as well as the brown wire both being in parallel are then connected to the other side of the fuse.
The black wire is hooked up to the
|
By
eric freedman
·
#49157
·
|
|
Re: Wave slap / banging under the stern
Hi Matt;
We’re not on board. Will look through photos to see if I have one to post.
Happy Sailing;
Mohammad and Aty
B&B Kokomo
AMEL 54 #099
Hi Matt;
We’re not on board. Will look through photos to see if I have one to post.
Happy Sailing;
Mohammad and Aty
B&B Kokomo
AMEL 54 #099
|
By
Mohammad Shirloo
·
#49156
·
|
|
Re: Antal 120x18 Composite Fibre jib block
Thanks for the replies. I soaked and rinsed and they have improved markedly. I plan on adding a lube as well.
Thanks for the replies. I soaked and rinsed and they have improved markedly. I plan on adding a lube as well.
|
By
Duane Siegfri
·
#49155
·
|
|
Re: Raw water pump on Volvo D3
Or but this: https://bigblueoceanmarine.com/jpr-vp0030da-jmp-marine-volvo-penta-replacement-engine-cooling-pump-replaces-volvo-penta-21141637/
I bought one and could not see the difference with the VP
Or but this: https://bigblueoceanmarine.com/jpr-vp0030da-jmp-marine-volvo-penta-replacement-engine-cooling-pump-replaces-volvo-penta-21141637/
I bought one and could not see the difference with the VP
|
By
Arno Luijten
·
#49154
·
|
|
Re: Antal 120x18 Composite Fibre jib block
Hi,
I grase my cars and blocks with "Harken one Drop" it is excellent!
Arnold
SY Zephyr
SM 203
Am 11.11.2019 um 23:06 schrieb Joerg Esdorn via Groups.Io <jhe1313@...>:
I asked Antal how to service
Hi,
I grase my cars and blocks with "Harken one Drop" it is excellent!
Arnold
SY Zephyr
SM 203
Am 11.11.2019 um 23:06 schrieb Joerg Esdorn via Groups.Io <jhe1313@...>:
I asked Antal how to service
|
By
Arnold Mente
·
#49153
·
|
|
Re: Antal 120x18 Composite Fibre jib block
I asked Antal how to service the blocks on my boat. They said rinsing with fresh water and a little grease.
joerg esdorn
A55 Kincsem
I asked Antal how to service the blocks on my boat. They said rinsing with fresh water and a little grease.
joerg esdorn
A55 Kincsem
|
By
Joerg Esdorn
·
#49152
·
|
|
Re: Wave slap / banging under the stern
We use swimming noodles as well (cut into smaller pieces so they closely follow the curvature of the hull).
Dennis
Libertad
Maramu 121
We use swimming noodles as well (cut into smaller pieces so they closely follow the curvature of the hull).
Dennis
Libertad
Maramu 121
|
By
sbmesasailor
·
#49151
·
|
|
Re: Victron Quattro charger/inverter installation
Hi James,
You may want to consider a 3 position high capacity rotary switch. This is what we did when we added an inverter. Our inverter had an internal transfer switch which we did not use.
Hi James,
You may want to consider a 3 position high capacity rotary switch. This is what we did when we added an inverter. Our inverter had an internal transfer switch which we did not use.
|
By
rossirossix4
·
#49150
·
Edited
|
|
Re: Down wind pole corrosion damage
The black rubber thing you removed is the chafing shoulder where the short pole rides on the main mast rigging. My guess is that sometime during the life of your Amel and while sailing with this pole,
The black rubber thing you removed is the chafing shoulder where the short pole rides on the main mast rigging. My guess is that sometime during the life of your Amel and while sailing with this pole,
|
By
CW Bill Rouse
·
#49149
·
|
|
Re: Raw water pump on Volvo D3
Hard to say without inspecting the pump. Often a lip seal makes a groove in the shaft after some times. Then it is time to change for a new shaft also.
However when the surface of the shaft at the lip
Hard to say without inspecting the pump. Often a lip seal makes a groove in the shaft after some times. Then it is time to change for a new shaft also.
However when the surface of the shaft at the lip
|
By
Gerhard Mueller
·
#49148
·
|
|
Re: Wave slap / banging under the stern
Have to agree with Mark and the others. Having cruised for a while now, during sleep your sailing brain seems to segregate normal noises (waves, wind, shrimp, rain, thunder, etc) from noises you
Have to agree with Mark and the others. Having cruised for a while now, during sleep your sailing brain seems to segregate normal noises (waves, wind, shrimp, rain, thunder, etc) from noises you
|
By
Thomas Kleman
·
#49147
·
|
|
Down wind pole corrosion damage
A small crack emerged from under the black cover on the inner down wind pole. I drilled out the cover's retaining rivets and saw the full damage. Visiting the local welder to discuss options. Glad I
A small crack emerged from under the black cover on the inner down wind pole. I drilled out the cover's retaining rivets and saw the full damage. Visiting the local welder to discuss options. Glad I
|
By
Thomas Kleman
·
#49146
·
|
|
Re: Wave slap / banging under the stern
Mohammed, photos?
~~~⛵️~~~Matt
Mohammed, photos?
~~~⛵️~~~Matt
|
By
Matt Salatino
·
#49145
·
|
|
Re: Wave slap / banging under the stern
Learn to sleep with a pillow over your head and hope your wife still loves you
Learn to sleep with a pillow over your head and hope your wife still loves you
|
By
Courtney Gorman
·
#49144
·
|
|
Re: Wave slap / banging under the stern
Hi Stephan,
We too were concerned about this but as Bill and Mark rightly say it just goes away as an irritant after a short time on board.
Peter
Peter Forbes
0044 7836 209730
ppsforbes@...
Carango
Hi Stephan,
We too were concerned about this but as Bill and Mark rightly say it just goes away as an irritant after a short time on board.
Peter
Peter Forbes
0044 7836 209730
ppsforbes@...
Carango
|
By
Peter Forbes
·
#49143
·
|
|
Re: Wave slap / banging under the stern
Hello Stefan;
After the first season aboard Kokomo about 5 years ago, we started looking for a solution for the “banging” you refer to. After a few iterations of trying different solutions, we
Hello Stefan;
After the first season aboard Kokomo about 5 years ago, we started looking for a solution for the “banging” you refer to. After a few iterations of trying different solutions, we
|
By
Mohammad Shirloo
·
#49142
·
|
|
Re: Wave slap / banging under the stern
Hi Stefan,
In the past, wehave effectively used swimming noodles. Put a rope through about three of themand attach each end of the rope to the furthest aft cleats on the toe-rail(level with the
Hi Stefan,
In the past, wehave effectively used swimming noodles. Put a rope through about three of themand attach each end of the rope to the furthest aft cleats on the toe-rail(level with the
|
By
Mark Erdos
·
#49141
·
|