That looks very complicated. We have one line, 24-30 mm diameter, with a spliced eye that fits on the center cleet, and then a fixed lengt with a hook in the end. Hälsningar Ann-Sofie

You can get one from Seapower Marine in the UK for £425 + VAT (20%). http://www.seapowermarine.co.uk I have enquired about getting a discount for ordering several, and also to see if the VAT is

Dear Thomas, dear Ameliens, after 3 weeks on the anchor I have to take back my thoughts for the hooks on the bow roller. The rope (for the anchor chain) is now clearly reduced. The diameter of the

Hello Everybody I am please to annonce that since this morning , I am the proud owner of the SM n° 476 ! My first ever boat ! It comes with a broken Climma 9EH AC unit in the salon as suspected by

Keran, Mark, If anyone winds up having a genset exhaust elbow made, I would like to have one also. Maybe added numbers will reduce the unit cost. Miles Bidwell s/y Ladybug, sm216

Mark, From the local Onan dealer we were quoted $1600, still pretty crazy. The internal geometry of the part is complex, with a partial water jacket, and they are typically investment cast. There is

Orion, The exhaust elbow is a relatively complex geometry that also fits into a fairly tight space. While I am sure replicating it from measurements and sketches alone could be done, the chances of

Ian and Judy, beewax seems to fit good for natural wood, thanks for that. All the best. Dieter Fal-lera Sharki #135 Von meinem iPhone gesendet

Hi Karen, Is it possible to temporarily remove it and measure for dimensions?

Thank you Mark Paul

Karen, I just looked up the price for a replacement for this part. US$2,269 is absolutely insane! I could make them out of 316 Stainless Steel for way less than that. I have to remove mine this

Paul, The track is Lewmar Size 1. It would appear that Bill used: 1 x Size 1 End Stop With Single CL Sheave (Lewmar Part # 29471031BK): https://www.lewmar.com/node/13230?v=26088 1 x Size 1 End Stop

I have looked at the set up Harmonie did, and might make similar, but I can,t see what make the track is for ordering control block. Currently I use a preventer to control the shape and position of

talked with incidnce sail again, and no problem they will do the foam luff. On my current sail I had no foam luff, but had a rope sewed in and that improved the shape a lot on the genoa when furled.

We installed a Webasto 10,000 BTU unit. Note that most other manufacturers do not outwardly state their units are dual cycle (so they don't have to replace parts under warranty). Webasto does. They

I have found that one can control the mizzen boom by centring it on the track and using a bang/preventer tackle to the chain plate either side of the coach roof. So upon tacking or gybing one simply

Hi Bob, Sorry it is 8k BTU. It works too well. Dometic model DTU 6k 230 vac 60 hz 410 IT WORKS ON 50 AND 60 hz. SXM digital display and cxp control cable. total cost a few years ago was about

Joel suggested that years ago, Fair Winds Eric Kimberlite Amel Super Maramu #376 ‘

Thanks Kent, The seals and some other stuff should be here tomorrow. I will install them in the heat of the Caribbean. Thank you so much ! Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Eric, Thanks for the lead on an almost “plug and play” idea with Dometic 10. Can you share some model details? model number, power, supplier, etc. Much appreciated Bob Nomad Amel Super Maramu