Mike, I have what I would call a "European" spec SM so I don't even have a pumpout riser in my holding tank at all. I just have a hole in the deck with a plug. I actually had to make a hose with a

Hi Mark. Thanks. And this is for others who may have a configuration nearer to ours. I believe the pumpout riser is probably the same. However In our hull #240, with manual pump, the riser from the

Hello all. I am looking for a source for 54mm stern tube hose for my stuffing box on my 1985 mango. 54 mm is equal to 2 1/8 inches. Preferably a U.S. supplier as we are located in the US and need it

Mike, Thankfully, I have not needed to tackle this job yet. However, I did remember seeing a post by Gary Silver posted that had a sketch of his holding tank system. You can find it here:

I am afraid there is no book of the Amel Sharki. There is only a flyer still available. You find the autopilot compass behind the portside backrest cushion in the saloon. -- Gerhard Mueller Amel

After years of various issues with the metal parts of the holding tank assembly, it seems we are now facing their complete failure. Pumpout now does not remove contents, indicative potentially of a

Hi Steve, I'm not aware of a gelcoat color number scheme and after many years of sun you may not get a perfect match even if you had the original factory color. However you can easily get an

thanks to everyonefor all infoam still looking for the original book of the amel sharkiand I would like to know where the autopilot compass isgood daygreeting walter Verstuurd vanaf mijn iPhone Op 12

I'm looking for a refurbished SP 155 TCi bow thruster motor. IMTRA in the U.S. said they only have the new SE170 available. Does anyone on this forum have experience with the SE 170? Is it a

Bonjour Olivier, I carefully cleaned the prop shaft to get good measurements. I read zero Ohms between prop shaft and the prop. But from prop shaft to zincs on the rudder I got a range of

Hi All, Does anyone knows the gel coat number of a SM 2005. We replaced the chart plotter outside and need to fill some holes. Tried to add a picture but was to big. Kindly Regards, Steven Nieman SM

I got mine from Amel. Fair Winds Eric Amel Super Maramu #376

Hi, Here is the photo. Once you have it apart have a machine shop open up the hole a few thousands of an inch. Fair Winds Eric Amel Super Maramu #376

Moin Gerhard, many thanks :-) Best Ralf

Bill , Might the gasket fit over the threaded opening and rest on top of the reservoir and the cap tighten down on top of it ,I see black marks on the bottom of the cap as though it had been in

Craig, I am amazed that you found a US source for these boxes! Thanks for sharing, I have added this information to my Sueno file. I will be in Florida myself pretty soon and will follow up.

Hi Bill. I would suggest it goes under the cap. Sometimes the material used expands with age. Regards and wishing you and Judy all the best for Christmas and the new year. I hope your new career

Hi Jer, I have used this person. He did a thorough job for me in RI. I was impressed and I recommend him. WILLIAM COBLE Independent Marine Surveyor P.O. Box 1434 North Kingstown, Rhode

Porter, Yes, it doesn't fit. The gasket is too large. Best, CW Bill Rouse Amel Owners Yacht School - www.AmelOwnersYachtSchool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

That the lid to the c-drive oil reservoir and associated gasket. Porter iBIS 54-152 Excuse the errors. Sent from my IPhone Www.fouribis.com