Thanks Alan, how did you separate the parts. Did you have to take the forestay down or did you do it in place. Regards Danny

Hi All We would also be interested to get the correct paint number for the trim on the Amel Redline models? Is there anyone out there that has this information, please? Kindest regards Colin & Lauren

Hi Arlo, We had the yard do it. They offer it as a service. We had it done in 2014, when we applied CopperCoat. Sorry, but I no longer have the yard bill, and can’t remember what we paid. I’ll

Hi Danny, Bad luck. We had that happen a few years ago and it is the slot in the plate that the pin engages in which becomes worn and under tension the pin can spring up and out of the slot. We

Matt, who did you have do it at Cape Marina? I will likely be getting it done next summer and I am at Cape Marina. Also what did they charge you if youndont mind me asking...

Hi all, the pin holding the headsail furler to the motor let go yesterday allowing the involuntary unfurling of the headsail. The pin must have lifted out of its hole to allow this to happen. The pin

We had the same done at Cape Marina, Canaveral, Florida. They did an excellent job. ~~~⛵️~~~Matt

We had it done to our Super Maramu last winter. It was done by a very experienced contractor 20 miles south of Annapolis who has over 25 years of experience with soda blasting boat hulls. I made it

Dear fellows If anyone needs a new pump or a maintenance kit, contact: info@... Francesca give me 6-8 weeks for a new pump: Diaphragm pump TM 50 24V DC 0,12Kw With body pump in PVC - 460

Hi Eric. Sorry for the delay in replying we are cruising in and put of email contact. I couldnt say the type of insertion rubber but i made the diaphragm out of 2mm. I thought of putting two in but

Hi Ruedi, In my opinion soda blasting is great at removing old paint and leaving a perfect surface for epoxy primer; so long as the operator knows what he is doing... That is a big caveat. In the

Alexandre, please send me your email address: russ "dot" roberts "dot" va "at" gmail "dot" com

Why don't you ask Amel? Best, CW Bill Rouse Amel Yacht Owners School - www.YachtSchool.us 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Looking for opinions from the AMEL Group about Soda Blasting Because I don’t’ know the history of the last 12 years on WASABI what was below the recent AF, how many layer of AF etc. I have in

Good morning Russ, I saved mine. It is about 35-40% used (but would prefer a sailmaker gives an exact state of use), need the bi-annual restitching. The only issue, it is in Sint Marten (where it

VF44 P1 60 P63B14 B3 SPEED REDUCER, 60;1 RATIO, 63 FRAME, B14 FLANGE , CODE: 200480249 Ian & Margaret S/V Loca Lola II SM153 US East Coast

Von meinem iPhone gesendet

He ian here a foto fro ouer gaerbox from Bonfiglioli . In the afternoon i can send a foto from the bill with part numbers . The Liroy Somer motor you can only order by Amel it was not possible to

I just took delivery for our Bonfiglioli unit. Lead time was several weeks. MITCH SILVERMAN DRIVETECH AUTOMATION, INC. 5401 NW 102ND AVE. #146 SUNRISE, FL. 33351 TEL: 954-746-9800 FAX:

Some have fitted the outhaul gearbox with grease fittings. How has that worked out? We have been trying to seal the top shaft with RTV where water lays to try to mitigate water intrusion and rust.