I'm sure others have done it before, but we don't use the staysail downwind. We either use it in lieu of the genoa in 28+ knot apparent winds upwind or just going upwind along with the genoa. The

Thanks Bill. My batteries are near the end of there life, and I’m interested in this upgrade. Steve Aloha SM 72 Hawaii

hi all, we changed all the electronics on KALI MERA from B&G to Raymarine. Some months before I renewed the B&G paddlewheel speed sensor, would sell it if someone needs it, is almost new. Just found

Thanks Scott, does this mean the running back stay is used up or down wind when the stay stay is used? I’m new to a ketch and have a lot to learn- regards Paul

I agree that you should ideally use the running backstay anytime you are using the staysail. I will say we do use the preventers anytime we go greater than 100deg apparent. It doesn't take long and

Sounds very effective, could I ask the total cost? Regards Paul

I don’t know off the top of my head but there is an output curve on their website which is pretty good. The big benefit is that it’s running all the time when you’re in 7 knots apparent or

Everyone, You know how cationary I have been regarding Lithium based electrical systems onboard an Amel. I had one client who had serious issues because the source he used failed to install all needed

Hi Joerg, Can you please send a photo of the installation of the super wind? Thanks, Ofer Magen Alba A54 160 Datcha area Turkey

Oliver, I suggest you try the calibration and parameters prior to any replacements or cleaning as my problem was similar to your issue Paul

Oliver, I had a similar problem with the boat speed reading and changed the sensors (not an easy thing to do) Unfortunately the reading was still 0. I then open the box and cleaned the contacts

Thank you again Bill for the kind assistance, this document helps and I will check and calibrate according, you are most kind Regards Paul

Sorry Oliver I am not sure but you should be able to down load from the internet, I have the FURUNO H3000 and found it on the internet... It is fairly simple if you get to the calibration page under

Rainer is correct. on the 83 maramu the slider rails are both glued and finish nailed to the facing which is 8 mm veneered ply. Dont try to remove the rails or you will deface the laminate..... on

Thank'you JL Mertz Garanti sans virus. www.avast.com

Maybe some of this will help: There is an adjustment to the B&G Sonic Speed Processor. See knob in above photo and attached. Best, CW Bill Rouse Yacht School (formerly Amel School) - Supporting

Paul, Where to find the manual for this sensor setup? Oliver A54#39 Sent from my Huawei Mobile

Hi everybody If someone is still interested in Hydra2000 or Furuno Equipment removed from an Amel54 (2007). - B&G Hydra2000 & Hydra Instruments, - B&G Processor, - Furuno NAVnet Chart-Ploter, Furuno

Bill, it worked fine all last season but when i commenced sailing this season the paddle wheel was not functioning due to barnacles so I replaced it and it stated STW off, then you pointed me to

Hi Joerg What is the general amps produced in various winds? Regards Paul 55#17