Paul, Where to find the manual for this sensor setup? Oliver A54#39 Sent from my Huawei Mobile

Hi everybody If someone is still interested in Hydra2000 or Furuno Equipment removed from an Amel54 (2007). - B&G Hydra2000 & Hydra Instruments, - B&G Processor, - Furuno NAVnet Chart-Ploter, Furuno

Bill, it worked fine all last season but when i commenced sailing this season the paddle wheel was not functioning due to barnacles so I replaced it and it stated STW off, then you pointed me to

Hi Joerg What is the general amps produced in various winds? Regards Paul 55#17

Hi, I got a sonic speed sensor and it was working before. Magnified Wind did not work since I got the boat. Where do I find a manual for sensor setup in Menue to verify the setup? Hot to test a

I have a Superwind half way up the mizzen mast and it is completely silent. I have a special connector between the mast bracket and the generator which makes the unit sit and rotate on a plastic

Paul, Your 54 didn't come with a Paddlewheel. Probably when it was added, parameters were not set...my guess. Your 54 came with Sonic Speed.

Hi Bill, my issue was similar except my paddle wheel and sensor was ok accept the parameter associated to the sow was not activated in the H300 display, this then gave me SOW and correct TW and

As you may know, there are only a few values displayed on the B&G Hydra (2000-5000) that are actual. They are AWS, AWA, SOW, and Depth. All of the other values, like True Wind Angle, are calculated by

I have two Rutland 1200’s on Amelia mounted on the Solar Arch/Dingy davits. They have been good and are near silent. My complaint is that they produce a resonance that is heard in the aft cabin.

Have you tried entering into Menu and then setup and then calibrate and the entering a source? I’d had the same issue I think and found a source was not assigned such as SOG or similar Regards

Good morning, I see people keep track of me!!! I am actually now in Fortaleza, Brazil. The wreck was shredded about a year ago (in St Martin). email: uster at rocketmail dot com or alternate

Hello, I got 2 issues with my B&G H2000: 1. The magnified Wind shows wrong values. It comes from extension processor. We replaced the instrument but still the same. 2. We stored on land for 12 month

Are you asking for the boat or for Alexandre? Ladt I read from Alexandre was on the 11 August then he was in Curitiba, Brazil. The boat might still be on St Martin Regards Ann-Sofie S/Y Lady Annila,

Can anyone give me the coordinates of NIKIMAT? Merci Jean Luc MERTZ On CottonBay

Just wrong charts! Sorry I missed you Danny....left for Oz at sparrows this am Fair winds Alan

Hi Eric I am very happy with the Rutland 1200 wind gens, and had researched these quite fully when we purchased back in April 2017. At that time all the reviews put them as one of the top three (Super

Hi Colin, What model wind generator do you like? Fair Winds Eric Kimberlite Amel Super Maramu #376

I only have one piece of advice, from experience, but it is the most important one: GET THEM TO MAKE UP THAT ALIGNMENT TOOL! It is not hard. The first 'competent' mechanic who took out our engine for

Fixed. dismounted, disassembled, cleaned, lubricated, sealed, assembled, installed. all original parts, including o-rings. Works better then new one :)