Thank you Olivier, I appreciate your knowledgeable input. Kind Regards Danny

You might want to think about AwlGrip Desert Sand, which is the new trim color for Amels since the introduction of the 55. --

Hello Danny, the type of locking pin you have is bolted into the aluminum sheave. The hole in the aluminum is tapped and the stainless steel unit is threaded. It is originally mounted with hard

I believe they use crushed walnut shells as the medium, not sand. Whatever it is, isn’t abrasive enough to penetrate the gelcoat. Careful selection of blasting media is important.......or you’re

Thanks Duane, it would seem the later models had a different set up from mine at model 299. My emergency pulley is in one piece so not possible to separate it. Likewise different to Alan's in that

Thank you Nick, Matt Arlo, Bill and Mark for your advice.. Ruedi WASABI AML 54-055 Syracus (Sicily) Von: "main@AmelYachtOwners.groups.io" <main@AmelYachtOwners.groups.io> on behalf of

Danny, I had to do the same problem two years ago. You need to remove the emergency rope furler from the foil. On my boat (SM#477) it comes off in two halves, one on each side of the foil. The pin

Thanks Alan, how did you separate the parts. Did you have to take the forestay down or did you do it in place. Regards Danny

Hi All We would also be interested to get the correct paint number for the trim on the Amel Redline models? Is there anyone out there that has this information, please? Kindest regards Colin & Lauren

Hi Arlo, We had the yard do it. They offer it as a service. We had it done in 2014, when we applied CopperCoat. Sorry, but I no longer have the yard bill, and can’t remember what we paid. I’ll

Hi Danny, Bad luck. We had that happen a few years ago and it is the slot in the plate that the pin engages in which becomes worn and under tension the pin can spring up and out of the slot. We

Matt, who did you have do it at Cape Marina? I will likely be getting it done next summer and I am at Cape Marina. Also what did they charge you if youndont mind me asking...

Hi all, the pin holding the headsail furler to the motor let go yesterday allowing the involuntary unfurling of the headsail. The pin must have lifted out of its hole to allow this to happen. The pin

We had the same done at Cape Marina, Canaveral, Florida. They did an excellent job. ~~~⛵️~~~Matt

We had it done to our Super Maramu last winter. It was done by a very experienced contractor 20 miles south of Annapolis who has over 25 years of experience with soda blasting boat hulls. I made it

Dear fellows If anyone needs a new pump or a maintenance kit, contact: info@... Francesca give me 6-8 weeks for a new pump: Diaphragm pump TM 50 24V DC 0,12Kw With body pump in PVC - 460

Hi Eric. Sorry for the delay in replying we are cruising in and put of email contact. I couldnt say the type of insertion rubber but i made the diaphragm out of 2mm. I thought of putting two in but

Hi Ruedi, In my opinion soda blasting is great at removing old paint and leaving a perfect surface for epoxy primer; so long as the operator knows what he is doing... That is a big caveat. In the

Alexandre, please send me your email address: russ "dot" roberts "dot" va "at" gmail "dot" com

Why don't you ask Amel? Best, CW Bill Rouse Amel Yacht Owners School - www.YachtSchool.us 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970