Agreed, damn electronics Thanks Bill, your a legend

Yep, L1 is the sensor, damn these new world sensors😀 Best, CW Bill Rouse Amel Yacht Owners School (formerly Amel School) - Supporting Amel Owners 720 Winnie St Galveston Island, TX 77550 +1(832)

Thanks Bill, I think your right with the Danfoss compressor controller and the alarm code could be L1 or something similar, I only saw the code for a moment then it switched off and would not switch

It is likely the starting capacitor inside the wiring junction box on the top of the Calpeda BCM20/E pump. Note the photo shows an aluminum case capacitor. Absolutely use an aluminum case 10uf

Paul, Frigoboat refrigeration with Danfoss Compressor controllers have an error code of 1 Flash from a LED across the "D" terminal and a "+" terminal on the Danfoss Compressor controller. This is a

Sounds like a starting capacitor is bad. ~~~⛵️~~~Matt

Hi Dean, I turn on the AC and nip into the engine room with a screwdriver. It is trying to turn but can not quite make it without my help. No kickback really. I had that pump apart and reckoned it was

Hi Nick, Ah the old screwdriver trick. That’s usually my first port of call too! Do you try to turn it when it’s powered up? Is there a kickback when it spins up? I’ve always powered it down

Hi I'm new to this group, thanks to the moderators for letting me join.any one have a manual and or a spec sheet for a1977,53ft Meltem.tjanks

Id like to add an inner stay to my 1977 meltem53.ive seen some close to each other and others about foot or two apart .what is the significance.

Where do you emptying the black water tanks,the toilets are backed up

Hi All, The thing that was niggling me was the fact that there was no voltage across the Active-Neutral terminals of the pump when I checked. Monitoring the terminal voltage I have checked whether

That’s an impressive blow out Jose! At least you know what is wrong very easily 😜

Scott, sorry for the delay but here are pics of the clean up tackle for the runners and the extension for the runners, as supplied by Amel. Works excellent.

Hi Dean, On my 54?I have to get the pump going with flat screwdriver on the shaft at the aft end there is a hole in the fan covering. Mine makes a hum but does not turn without a little

good day to all, my Freezer is a ‘frigoboat’ with its controller being ‘Carel IR33’ and yesterday just stopped working with no warning except the controller displayed ‘1’ If anyone can

Bernd, This is a LofransTigres windlass. Parts are readily available worldwide. https://www.lofrans.com/spare-parts The buttons arean Amel add-on and are available from Amel or from

All, I am mostly finished with recommended assortments/bundles including the required peripheral devices. I have selected a Preferred Vendor for the US & Canada and another for the UK and Europe. I am

The Winsh is a lofranz Tiger Look by svb there you find any spareparts Von meinem iPhone gesendet

Hi, another one. I need to service my windlass and especially the up/down switches which have gone with the sun n salt. Unfortunately I have no idea what’s the name/model of mine. It looks very