Is this the box: If so, Mark is correct...and more importantly, failure of this relay means that you should not operate the generator until the relay is replaced, or the relay is replaced with a

All SM 53's have a galley extractor fan. Be sure to remove the fiberglass Amel arrow insignia on the port side and place some aluminum gridding like what is used at the bottom of a screen door as a

Thanks for the explanation Mark. I rarely connect to shore power (650W solar panels), but I’ll try to replace it with an equivalent automatic switch. But out of interest, if you install a manual

This LC1 D25008 is the switch that changes you automatically from shore/gensetpower. The wiring of this device can be somewhat confusing to the novice. Ifyou are unsure, get an electrician. The

Hi yesterday I connected to 220V shore power, sockets worked as usual. Then I switched on the 220V battery charger and aircon. A few seconds later all 220V power stopped and there was a burning smell

SM Balu 222 I have one Von meinem iPhone gesendet

SM153 has one. Ian & Margaret S/V Loca Lola II SM153 US East Coast

For what it's worth- sm2k 422 has one.

Hi Carina, Can you send me your Email address – I have some questions related to such a move My Email address:teun@... teun @ amelit dot net Thanks Best Regards Teun SV AMELIT A54

I own SM 72, and have one. Steve Davis Aloha SM72 Hawai’i

Seems a strange question to ask - but Do all SM's have a extraction fan over the cooktop - I seem to see some pictures with them - and others it is hard to tell. Or was this an option that only some

Thomas, Although Bill correctly points out the expansion tank takes care of the increased pressure, it may be helpful for you to know how it does that so you understand that it's not extra water

Thomas, the purpose of the hot water accumulator tank is to take care of the increased pressure in the hot water system caused by heating the water. Heating water increases the pressure in a closed

Bill- thanks as always for the great info. So this tank is just an 8 liter reservoir for my basic 40 ? Does it only allow ingress under some kind of pressure ? If not it merely expands my basic 40

Hi Greg; We hauled out at Manoel island in Malta last year. Although I do not have first hand experience, I was told by a reliable source that they had very good painting contractors in

Thomas, On your SM the hot water pressure accumulator tank was originally located between the water heater and the port side of the engine room. Unfortunately, I have seen some owners remove this tank

Tom has identified his problem - no expansion tank, but I think this topic started with Mawgan's problem of no hot water flowing after he installed a new tank. Mawgan, how did that work out?

Hi Greg, Check out Agmar Marine's Partheni Boatyard next to the airport on the north end of Leros. Very skilled workers and, although I didn't have painting done, I did see their work and it was

Bill- I definitely have no accumulator tank in the circuit. I just thought all these years that the basic 40 had a relief valve set too low (7 bar ?). These relief valves tend to last me 1-2 years (I

SevenStar is perfect for this. I am sending you a private message. Best, CW Bill Rouse Yacht School (formerly Amel School) - Supporting Amel Owners 720 Winnie St Galveston Island, TX 77550 +1(832)