|
Re: super maramu, vibrations generated when the engine is running
Nick, same as SM. There is a rubber bushing sleeved around that bolt. This is exactly what I am talking about.
Nick, same as SM. There is a rubber bushing sleeved around that bolt. This is exactly what I am talking about.
|
By
CW Bill Rouse
·
#46431
·
|
|
Re: supplemental downwind sailing configuration for Super Maramu
Jose,
Very cool!
I guess I haveone more question. Where did you buy this and do you have part number? (thatmight be two questions)
With bestregards,
Mark
Skipper
Sailing Vessel-
Jose,
Very cool!
I guess I haveone more question. Where did you buy this and do you have part number? (thatmight be two questions)
With bestregards,
Mark
Skipper
Sailing Vessel-
|
By
Mark Erdos
·
#46430
·
|
|
Re: supplemental downwind sailing configuration for Super Maramu
Did you have to modify the ballooner and add a gaiter?
NO
Where do you attach it to on the foredeck?
Directly to the anchor support plate standard hole
Did you have to modify the ballooner and add a gaiter?
NO
Where do you attach it to on the foredeck?
Directly to the anchor support plate standard hole
|
By
Jose Venegas
·
#46429
·
|
|
Re: super maramu, vibrations generated when the engine is running
Thank you Bill, I will check this point at first,
Jean Luc MERTZ
On CottonBay
Le 21/06/2019 à 15:34, CW Bill Rouse a écrit :
Garanti sans virus.
Thank you Bill, I will check this point at first,
Jean Luc MERTZ
On CottonBay
Le 21/06/2019 à 15:34, CW Bill Rouse a écrit :
Garanti sans virus.
|
By
jlm@jlmertz.fr
·
#46428
·
|
|
Re: super maramu, vibrations generated when the engine is running
Thank you for the tip I will check it
Merci Beaucoup
Jean Luc MERTZ
On CottonBay
Garanti sans virus. www.avast.com
Thank you for the tip I will check it
Merci Beaucoup
Jean Luc MERTZ
On CottonBay
Garanti sans virus. www.avast.com
|
By
jlm@jlmertz.fr
·
#46427
·
|
|
Re: super maramu, vibrations generated when the engine is running
Yes they do and the mechanical gay was experiment with AMEL SM
Merci
JLMERTZ
Le 21/06/2019 à 10:52, eric freedman a écrit :
Garanti sans virus.
Yes they do and the mechanical gay was experiment with AMEL SM
Merci
JLMERTZ
Le 21/06/2019 à 10:52, eric freedman a écrit :
Garanti sans virus.
|
By
jlm@jlmertz.fr
·
#46426
·
|
|
Re: super maramu, vibrations generated when the engine is running
Yes they do and the mechanical gay was experiment with AMEL SM
Merci
JLMERTZ
Le 21/06/2019 à 10:52, eric freedman a écrit :
Garanti sans virus.
Yes they do and the mechanical gay was experiment with AMEL SM
Merci
JLMERTZ
Le 21/06/2019 à 10:52, eric freedman a écrit :
Garanti sans virus.
|
By
jlm@jlmertz.fr
·
#46425
·
|
|
Re: super maramu, vibrations generated when the engine is running
Super Nick,
It is exactly my conclusion bat the two fixed prop are perfect, so I could not image it could be possible ...
Before to turn back to Autoprop (actually as spare) I will
Super Nick,
It is exactly my conclusion bat the two fixed prop are perfect, so I could not image it could be possible ...
Before to turn back to Autoprop (actually as spare) I will
|
By
jlm@jlmertz.fr
·
#46424
·
|
|
Re: super maramu, vibrations generated when the engine is running
Hi Bill,
On the 54 there is a bolt covered in black mastic from the bottom of the C drive to the iron keel. Presumably this anchors the C drive. Is there any adjustments or anything to look out
Hi Bill,
On the 54 there is a bolt covered in black mastic from the bottom of the C drive to the iron keel. Presumably this anchors the C drive. Is there any adjustments or anything to look out
|
By
ngtnewington Newington
·
#46423
·
|
|
Re: super maramu, vibrations generated when the engine is running
On a C-Drives older than 1999, don't forget to check the C-Drive foot for side-to-side movement by pushing on the aft end of the foot. No more than 8-10mm. If you have more, remove the foot bolt to
On a C-Drives older than 1999, don't forget to check the C-Drive foot for side-to-side movement by pushing on the aft end of the foot. No more than 8-10mm. If you have more, remove the foot bolt to
|
By
CW Bill Rouse
·
#46422
·
|
|
Re: Eberspacher 5L diesel heater
Hi Duane, what were your symptoms? How long does it run on heat mode? Does the thermostat shut it down when it's warm?
Mine runs for about 7 mins just fine then stops. It has done this for a while but
Hi Duane, what were your symptoms? How long does it run on heat mode? Does the thermostat shut it down when it's warm?
Mine runs for about 7 mins just fine then stops. It has done this for a while but
|
By
Alan Grayson
·
#46421
·
|
|
Re: Boston E 14, new Bamar Furler
The old E14 will work fine.
Jeff s/v Spirit Amel 54 #14
The old E14 will work fine.
Jeff s/v Spirit Amel 54 #14
|
By
JEFFREY KRAUS
·
#46420
·
|
|
Re: Eberspacher 5L diesel heater
Hi,
I spray all electrical connections with marine crc, or WD 40 or Corrosion x. All work for me and avoid these corrosion problems.
Regards
Danny
SM 299
Ocean Pearl
Hi,
I spray all electrical connections with marine crc, or WD 40 or Corrosion x. All work for me and avoid these corrosion problems.
Regards
Danny
SM 299
Ocean Pearl
|
By
Danny and Yvonne SIMMS
·
#46419
·
|
|
Re: super maramu, vibrations generated when the engine is running
Hi I am at Lakka, but moving round to Gaios this pm.
Nick
Hi I am at Lakka, but moving round to Gaios this pm.
Nick
|
By
ngtnewington Newington
·
#46418
·
|
|
Re: super maramu, vibrations generated when the engine is running
Did they use the special alignment tool when installing the engine back into the C drive?
Fair Winds
Eric
Kimberlite Amel Super Maramu #376
Did they use the special alignment tool when installing the engine back into the C drive?
Fair Winds
Eric
Kimberlite Amel Super Maramu #376
|
By
eric freedman
·
#46417
·
|
|
Re: super maramu, vibrations generated when the engine is running
I have heard Yanmar is particularly bad with going thru mounts. Some engines do not run smoothly, some do.
I have heard Yanmar is particularly bad with going thru mounts. Some engines do not run smoothly, some do.
|
By
arthur saftlas
·
#46416
·
|
|
Re: super maramu, vibrations generated when the engine is running
Hi Nick, we are anchored outside next to the power boat. Would you like to come for coffee.
Barry and Penny
“Lady Penelope II”
Amel 54. #17
Paxos Greece
Hi Nick, we are anchored outside next to the power boat. Would you like to come for coffee.
Barry and Penny
“Lady Penelope II”
Amel 54. #17
Paxos Greece
|
By
Barry Connor
·
#46415
·
|
|
Re: Eberspacher 5L diesel heater
Sounds like you should consider applying a “conformal coating” to the PCB. This is like a thick lacquer that prevents corrosion and is a standard process in preparing PCBs for harsh environments.
Sounds like you should consider applying a “conformal coating” to the PCB. This is like a thick lacquer that prevents corrosion and is a standard process in preparing PCBs for harsh environments.
|
By
Dave Ritten
·
#46414
·
|
|
Re: super maramu, vibrations generated when the engine is running
On my last boat I used to have a fixed three blade prop and there was some vibration. It was a traditional shaft and stern tube arrangement. I spent ages realigning the engine. Then I pulled the
On my last boat I used to have a fixed three blade prop and there was some vibration. It was a traditional shaft and stern tube arrangement. I spent ages realigning the engine. Then I pulled the
|
By
ngtnewington Newington
·
#46413
·
|
|
super maramu, vibrations generated when the engine is running
Hello everyone
I have two friends who have a SM (1997 and 1999) who after having changed all the mounts and the coupling of the engine have a significant residual vibration.
Both have the distinction
Hello everyone
I have two friends who have a SM (1997 and 1999) who after having changed all the mounts and the coupling of the engine have a significant residual vibration.
Both have the distinction
|
By
jlm@jlmertz.fr
·
#46412
·
|