I am resending this because the first email did not really look correct with HTML A B C D E R Figure Letter (See Above)

Kent, If I am not mistaken, they have exactly what I think will work best, which is CACD240: A B C D E R Figure Letter (See

Ian and others: I cannot account for why I was told the rubber button was not a Goiot part, but, in fact, when I contacted Goiot France to buy some sun screens for the Traditional ports, they put me

What about Kalamata? I'm here now for about a year. -- Gerhard Mueller Amel Sharki #60 Currently Kalamata, Greece

Hi Joerg Thanks for the information. So you use your parasailor without the pole, do you find it easy to launch and retrieve without issues and what wind do from good from and up to? Obviously it

One more vote for Basimakopoulos. My boat was on the hard there for the winter 2017/18. The yard and their contractors do excellent work and prices are reasonable. They will connect you with a very

Paul, I have a Parasailor and I use it without a pole. It's attached to the forestay with an ATN Tacker. It's much more stable than a symmetrical or asymmetrical spinnaker and much more forgiving -

Hi Nick, We are ashore at Basimakopoulos Shipyard in Kilada. There is no marina but an excellent, protected anchorage and good storage ashore. The village is a small fishing village where everyone

Kent, Sometimes they have minimal staff during shutdown. Best, CW Bill Rouse Yacht School (formerly Amel School) - Supporting Amel Owners 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970 My

Will do, Bill. I guess I’ll have to wait until next month, eh? Kent Robertson Kristy SM 243

Thanks Danny, are they half-round ie 1” x 1/2”, or taller ie 1” x 1”? Kent Robertson S/V Kristy SM 243

I would order it from Amel. It will be the right size (metric) and come pre-cut and ready to install. Best, CW Bill Rouse Yacht School - Supporting Amel Owners www.YachtSchool.us 720 Winnie

Hello fellow Amel owners. I have been enjoying the Ionian Greek cruising ground and am planning to end up the other side of the Peloponnese maybe in Aigina by the end of October. I know there are a

Thank you all for the great information. I saw that BEKO WMS6100 is not produced any more but there a few machines on the market that could fit in. The different models changes very quickly on the

Hi Kent and Bill. I checked on Ocean Pearl today and all the hatch seals unquestionably have the large hole in the center Regards Danny SM 299 Ocean Pearl

Here’s the site I was looking at. These are truly half-round with base 1”, height 1/2”(not 1”). http://www.acmerubber.com/round.htm I’ll contact them and Steve’s site to see if I can find

Hi again, im ready to order packing material for the first Tim and see that it comes in several sizes, from 1/8”-5/8” in 1/16” increments. Which is appropriate for a SM rudder

Elaine, Will you split this? I just need the sonic transducers. I’s also be interested to know which Onan parts you have. Cheers, Paul S/Y Ya Fohi - Amel 54 #98

Thank you for the info. Steve

Steve, Note that Trim-LOC says it uses EPDM Rubber. EPDM is related to polyethylene...I assume that this will be similar to polyfoam. The specs state that "compression Rating Recommended 25%