I have the tank cleaned and polished today. We pulled about 60 gallons out which matches the 1/4 level on the gauge. We're still unsure though as last time we were at 1/4, we added 106 gallons to what

Thank You, Thank You, Thank You. I have been sanding, cleaning this door for months after the 2nd Captain put some teak stain on to make it look pretty. Building my muscles lifting it up and pushing

Il 24/02/2021 14:35, CW Bill Rouse ha scritto:

I'm in the process of replacing the shaft bushing on my SM. How do you make sure the drain plug with the large slot for the line cutter is allaigned and firmly tighten at the same time? I was thinking

When others have checked with Amel, they were told no, but things always seem to change. I would check. This may help you. Replacement for Weather Strip on SM.pdf

The commutator looks fine so I've been trying to find the brushes. :) Any ideas where I can get that? -- Scott 2007 A54 #69 SV Tengah http://www.svtengah.com

Hi all, I solved the problem of the excess friction of the vertical sliding part against the bottom rubber scraper with the application of common talcum powder, with the advantage of avoiding anything

Thanks to you all, specially for the nose clip idea that I like the most. So I don't need this part for an outboard motor. When someone is around, I like to give it away. Best regards Stefan A54

Hello Scott, You can find a new engine for 375 € https://www.tyboat.com/achat/P-28464-raymarine-moteur-de-remplacement-pour-verin-electrique-type-2-24-volts.html regards Dominique

Hi Stefan; This is used for connecting a water hose to the water intake to flush an outboard engine for the tender. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

Hi is it possible to get the rubber scraper (for the companionway) from AMEL or other source? Regards Jarek NOA BLUE

Martin (B), How did your linear AP fail at 60,000nm? What specifically failed? We had an issue where the brushes in the electric motor wore down to almost nothing. We swapped the motors from our

 Hi Stefan, It’s muff for flushing an outboard engine with fresh water. Best regards Mike & Peta Solitude SM 2K 461

It’s for flushing the outboard motor. You connect a garden hose to it and it clamps to the foot of the outboard so you can feed fresh water. ~~~⛵️~~~Matt

I use a dry silicone like sailkote or a similar 3m product both on the rubber gasket on the vertical part of the companionway as well as the sliding hatch. The hatch needs to be sprayed in the

I like 3M Silicone Lubricant - Dry Version. You will find many uses for it. But be sure that the rubber scraper seal at the bottom of the door is not sticking and folding over. If it is, use this same

Rabbit ears, You put the across your outboard motor water intake and hook it up to a garden hose. You can then Run your outboard while attached to the rail. Good way to wash out the salt. There is

Eloi, I assume you mean the part of the companionway that slides horizontally. Over time, with many openings and closings, the fiberglass surface wears down, and it touches in places it shouldn't

Its for applying water to an outboard motor while it’s out of the water.

Nose clip