Thank you for the tip I will check it Merci Beaucoup Jean Luc MERTZ On CottonBay Garanti sans virus. www.avast.com

Yes they do and the mechanical gay was experiment with AMEL SM Merci JLMERTZ Le 21/06/2019 à 10:52, eric freedman a écrit : Garanti sans virus.

Yes they do and the mechanical gay was experiment with AMEL SM Merci JLMERTZ Le 21/06/2019 à 10:52, eric freedman a écrit : Garanti sans virus.

Super Nick, It is exactly my conclusion bat the two fixed prop are perfect, so I could not image it could be possible ... Before to turn back to Autoprop (actually as spare) I will

Hi Bill, On the 54 there is a bolt covered in black mastic from the bottom of the C drive to the iron keel. Presumably this anchors the C drive. Is there any adjustments or anything to look out

On a C-Drives older than 1999, don't forget to check the C-Drive foot for side-to-side movement by pushing on the aft end of the foot. No more than 8-10mm. If you have more, remove the foot bolt to

Hi Duane, what were your symptoms? How long does it run on heat mode? Does the thermostat shut it down when it's warm? Mine runs for about 7 mins just fine then stops. It has done this for a while but

The old E14 will work fine. Jeff s/v Spirit Amel 54 #14

Hi, I spray all electrical connections with marine crc, or WD 40 or Corrosion x. All work for me and avoid these corrosion problems. Regards Danny SM 299 Ocean Pearl

Hi I am at Lakka, but moving round to Gaios this pm. Nick

Did they use the special alignment tool when installing the engine back into the C drive? Fair Winds Eric Kimberlite Amel Super Maramu #376

I have heard Yanmar is particularly bad with going thru mounts. Some engines do not run smoothly, some do.

Hi Nick, we are anchored outside next to the power boat. Would you like to come for coffee. Barry and Penny “Lady Penelope II” Amel 54. #17 Paxos Greece

Sounds like you should consider applying a “conformal coating” to the PCB. This is like a thick lacquer that prevents corrosion and is a standard process in preparing PCBs for harsh environments.

On my last boat I used to have a fixed three blade prop and there was some vibration. It was a traditional shaft and stern tube arrangement. I spent ages realigning the engine. Then I pulled the

Hello everyone I have two friends who have a SM (1997 and 1999) who after having changed all the mounts and the coupling of the engine have a significant residual vibration. Both have the distinction

Hi all, We have the 5L diesel heater on Wanderer. It wasn't working when we bought the boat, and I had it checked when we were in Jamestown last August. The tech right away found it was the PCB that

I love mine and have been using it daily across the North Atlantic trip to Azores. Great images from Boston and now Northwood. Very easy to use - just leave it running and check it in the forecast

Jose, Very cool! Two questions:Did you have to modify the ballooner and add a gaiter? Where do you attach itto on the foredeck? With bestregards, Mark Skipper Sailing Vessel-

We keep our boat at Herrington Harbor North (https://www.herringtonharbour.com/north/) They also operate another marina just 1 mile south (https://www.herringtonharbour.com/south/) They are about 20