I would save your money on the wind. Best, CW Bill Rouse 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

I had an 80A charger from the time I bought Kristy and it was plenty. I’ve added Solar since then and rarely run the charger for more than 45min per day. Still thinking about a wind generator at

Well done. But wait to see the detail before you open the champagne. Danny SS 299 Ocean pearl

Congratulations Fair Winds Eric

Back in December Helvetia (subscribed through DeLassee Insurance) made a better (still very unfair) offer, which my french lawyers pressed me to accept, but it came with a special clause or exemption

When I purchased Amelia in 2017 both Dolphins were dead. I replaced the 100 amp with a Xantrex inverter charger(Special offer at Budget marine Grenada)8 and a 30A Mastervolt, which still works fine

.....king Mastervolt

Hello James, excellent that are the pictures I was looking for! Thank you very much. All the best, Frederic

Kent, why did you choose the 80/24 vs. the 100/24? Ian & Margaret S/V Loca Lola II SM153 Exumas, Bahamas

Hi there Stainless steel is smoother & harder, therefore may be better choice to keep lines under tension & avoid chafing Under heavy stress; do not know effect of heating when tension is constant &

I have had the Skylla 80/24 for 3 years now for my 520AHr bank of deep cycle lead-acid batteries. So far no problems whatsoever. Kent SM 243 Kristy Kent Robertson S/V Kristy karkauai@... USA cell:

We have had a Victron Skylla 100/24 on Elyse since the old Dolphins died 5 years ago. Very good experience, no problems at all. Very flexible and versatile charger, mode selectable for all types of

We have now had the second Leroy Somer motor shaft shear off where in enters the gearbox. First the outhaul 2 years ago, and now the mainsail furler. Sheared at same location. Rust evidence of

Amel installed the foam on these lines to keep the lines from twisting around other lines and each other. Usually a hard tug on the leader line will work. I believe there are at least 3 leader lines

Hi Christian, Thanks for the hint. I checked out the web site and believe that I can find a good solution with them. For friction reduction, I wonder if Stainless Steel or Aluminum is preferable. Fair

Any one using the victron skylla 100/24 ? I'm persuaded that I should probably buy a 100 amp charger for my generator-driven battery charging but realize that earlier SMs used an 80 amp

Hi there Gary, I sail an old timer 'Maramu' & 2 years ago did some maintenance on the power & signal cables running to the top of the mast, to find that whatever the strength of the leader lines they

hi there Keith check http://www.asap-supplies.com they have a wide range of alm & ss fairleads made by 4 DEK UK which accomodate old fashioned deck arrangements guess you may find proper replacement

Tom, Victron Energy,in my opinion, makes the best chargers. With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising - San Blas Islands,

Now, that’s funny! From:main@AmelYachtOwners.groups.io [mailto:main@AmelYachtOwners.groups.io] OnBehalf Of CW Bill Rouse Sent: Sunday, April 28, 2019 6:25 AM To: