Dear Oliver, thx. That seems to be a good idea too. Maybe I prefer this when I have to struggle with the freezer (locker) more then 2 or 3 hours. This will be my work for the weekend :-). Best

How about this staff: https://www.amazon.co.uk/Active-oxygen-tablets-chlorine-free-10/dp/B06XDTMJN4

Hi Ruedi I disconnected the hose from the galley panel, attached a strong mousing line and pulled it out through the engine bay and took both hoses to be copied. It was easy to pull the new hose

I've had pretty good luck so far doing an alternating system of bleach and Star right purifier. Since we travel.quite frequently and use the watermaker fairly regularly the water in the tank stays

Tony, I agree with Mohammed. The hoses could break at anytime. The saltwater, a broken high pressure hose will spray throughout the engine room, will cost thousands of euro. Bill Rouse

The SM & 54 have 2 partitions inside the freshwater tank and 3 inspection ports. The partitions do not go all the way to the bottom of the tank allowing water to flow throughout the entire tank. The

Hi Reudi; I ordered 10 meters of hose (enough for two replacements on Kokomo) and 4 HP hose connectors needed to make the two hoses. The connectors come with a special tool needed to make up the

Hi Tony Thank you. I unscrewed and checked the space behind the Panel. How did you replaced? There is very little space behind to access, I can even not get a Hand in! Did you accessed from the

We cleaned the water tank on our 54 shortly after purchase. We know Amel did not build all boats the same but I cannot believe they would make a significant change such as going from one to three

Also if you get a chance to spend a few days in biscayne bay, its a really pretty place to hang out and sail, and plenty of good anchoring spots there. If you come into the bay take the stiltsville

Good news. CorrosionX will help. Best, CW Bill Rouse Yacht School - Supporting Amel Owners www.YachtSchool.us 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Hello, I got same setup. Its mandatory to get bets matching the small pully belt disk size and that are possible to get tighten over the back. Some lawnmower belts do that. I got now some OPTIBELT

You need to flush carefully afterwards with lots of water....

Hello, I got the same problem. I could imagine that dishwasher detergent might do a better job than chlorine. This dishwash detergent has chemicals that break down organic matter from the algees or

I have a 175A 24v alternator on my 54. With twin pulley v belts. It is the set up with the alternator to port and separate from the 12v alternator and raw water pump belt. I know some 54’s are set

Thank you Barry You made both hoses new as I understood.The inlet from the Pump (maybe 1-1,5m) , and the outlet tothe Controls Board in the Galey which was slightly more than 3Meters, Right? Do

Thanks to all of you. The chemical mace is usually not my favorit. So I will try to dismantle the kitchen locker with the freezer completely. If this is successful and discovers some secrets I will

Hi Ruedi, Should have checked that hose when we were together. Nicholas at Dessolator gave me the fitting needed to retighten these hoses. My hose covers peeled off last year. Nicholas actually made

Success this morning. Voltage sensing cable to regulator had a loose connection at the alternator. That connection was very difficult to get at ... So now voltage at regulator is about .3V HIGHER

Hi Ruedi I replaced my Dessalator hoses in Corfu recently. I got them made (next day service) with stainless steel fittings (not cheap at €270 for the pair but good quality) at a farm equipment