Hi Alin, Who is the Dessalator rep in NZ ? Cheers Alan Elyse SM437

Thanks Danny we will give it a go ! It is a big sail and a small gap ! All the best Miles

Hi Miles, the big genoa is a lot of sail to drag around the stays. I use a technique to reduce this. As I swing into the tack and the sheet is released I begin to furl the sail. By the time I am head

Hy I think this Part is for your Dingy to sit inside on my dingy i habe the same part out of plastic Regards Joachim Gesendet von Yahoo Mail für iPhone Am Montag, Oktober 29, 2018, 1:25 PM

Hi, Can you post a picture or diagram? I am in the process of modifying ours but am having trouble envisioning it. Thanks, Bob KAIMI SM429 Gibraltar

Thanks Ian...had not seen it done that way before, and it sounds quite simple. Hope you two are doing well, and looking forward to another sailing season next year. Aloha, Steve And Liz Hawaii

Steve We had ours replaced by Amel in Martinique this year. They just used a knot in each end on a captive shackle, no splice. I suppose the advantage of a knot is that the halliard pulls up tighter

Thanks mate.

This it the price I received from Iwaki. Fair Winds Eric Kimberlite Amel Super Maramu #376 Here is your quote request MD-70RLZT-220: List cost = $560.00 ea.

Thank you. I got in touch with NZ Dessalator rep, will wait for them to send it and will mention what you said. Do you have any idea how much was yours?

Hi, I had 2-35 Gallon aluminum tanks fitted into the port “liferaft “ locker. They are each independent of the main fuel tank. Each one has a fuel fill, a vent, and a pickup tube connected to

The Dessalator representative in Maine has both the Calpeda pump and an Iwaki Pump which is much less money that the Calpeda pump. The Iwaki pump works fine for my Watermaker which is the same as

hey craig I was going to call you on this. Do you have a hard bimini now?

Thanks Duane...Happy Thanksgiving. Steve

Yes! Happy Thanksgiving from Aruba where we just had the mostawesome traditional Thanksgiving meal (lots of American tourists here who theisland cater to very well) With bestregards, Mark

Thanks so much Bill

Steve, There are two in the Photo section. Search for "Ballooner" or use this

Alin, You have the Dessalator D150/160 water maker. The low pressure feed pump spec is 900 liters/hour. You can buy the exact 230VAC 50htz replacement at www.dessalator.com. Best, CW Bill

Hi Alexandre. Thanks for your answer. My one is a bit different. Pls see the pictures, I didn't include the primary pump as it is removed. Maybe I will send a picture latter. Thanks. Alin

Does anyone have a good picture of how the looped end of the ballooner halyard is spliced by Amel. The one on our boat is not original, and probably not correct. Thanks for the help. Steve