A small correction: The difference in strength between galvanized G40 and G70 is not anywhere near a factor of 2, it is actually more like 20%. G70 chain is, however, roughly 2X as strong as G30

Hi Paul, I too have an Amel 54 and am replacing my rusty chain. If you have the same as me it will be 10mm ISO and grade 70. There are two options on the galvanised chain readily available, namely

Hi all, Some questions about anchor chain: 1. How do Iknow what size it is? Do I measure the internal/external longways diameter of a link? 2. Should I be concerned about a bit of rust - is there a

Bob, That looks like a good price on the seat , 33% off , significantly less than on Ebay. I just order one and shipping was free. Thanks, Pat SM123

Herbert, The stainless part that Olivier photographed is called by riggers in the USA a "Spinnaker Crane." There are several models available prefabricated commercially. I am not sure if any of the

Hi Olivier, thx for the pictures, this was exactly what I was looking for. I will do it in a similar way. you are always such a great help! herbert SN120 KALI MERA

I think Vetus sells one they call the Ferry seat....should have a US supplier... https://www.mauriprosailing.com/us/product/VTSCHTBSW.html (sold without pedestal) Bob, KAIMI SM 429 Cannes

Thanks John, i don't have any difficulty...I have the seat! Cheers Alan Elyse SM437

Alan if you have difficulty I could possibly help; but not until the last week in September when I return to NZ from Central Asia. My direct email is johnhayes862@... Cheers John

That’s where mine is, Pat. I get great reception and couldn’t be happier with it. Kent SM 243 Kristy

If you want you can disregard the question/post about the Iridium Go antenna. I spoke with a tech support ,that did not think it a problem. Thanks, Pat

Thanks Joel ,good to know. Pat SM123

Interestingly on Page 26 ...it says "....the VETUS desalinator......" Were VETUS selling Dessalator products at that time ? ....or ....?? Cheers Alan Elyse SM437

Pat, the low pressure gauge failure is not uncommon. About one third of the Amels I get for resale have failed low pressure gauges and owners who have replaced them more than once... JOEL F.

Right or wrong,good or bad, I went ahead and ran it in our fresh/brackish Sassafras River. After three years idle all went well , no leaks but I never went above 140 Lt/hr. and no where near the green

PS: A little more reading on Filmtec was interesting in that their BW and FW are indeed manufactured to very different specs than the SW, being designed for constant use in those waters. Less

Thanks!!!! With bestregards, Mark Skipper Sailing Vessel- Cream Puff www.creampuff.us From:amelyachtowners@... [mailto:amelyachtowners@...] Sent: Saturday, August 25, 2018 9:23

The easiest place for me to mount the antenna would be on the very aft starboard railing , however that means the antenna would be partially blocked from a clear view of the sky by my arch with solar

Thanks for sharing the experiences. I think that I will get a couple gallons, light sand and focus on the waterline, bow and rudder. My plans are to haul again next hurricane season and then apply

Two years ago when my fuel level was down below 100 liters I opened the inspection ports on the fuel tanks and inspected the inside of the tank. There were several small patches of sludge on the