I guess I need to add this to the list of things to do one day. What are thespecs of the replacement screws? With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K -

Hi Thomas, In the best Italian tradition the information is not very clear to discover, but if you go to https://nautikulma.fi/PDF/248-Veco.pdf, in the PDF at page 44 you will find the devices I

this12 volt pump can bé found in Osculati catalog at About 80 € If his pump does not work probably the reason is on the carbons that can be easely checked and changed It is also necessary to clean

Bill, Hi there.... is this the screw for the job, from grainger? I think I might be needing this soon on my SM #56... Got some butyl tape ordered too...so would I unseat the stanchion, clean the rust

Hey Kent, What line are you calling the "Tack Rope"? Sounds like an asym spinnaker pendant (non-Amel). Craig ---In amelyachtowners@..., <karkauai@...> wrote : I am replacing my running rigging prior

Out of curiosity I asked Veco (Annapolis Frigoboat/Climma distributor) about their warning to use only sea water for cooling, not tank water. My questions are below with their answers in red. "Dear

Hi Bill, is this the screw for the job? From the grainger site... I think this will be a task I'll have to do soon on my SM #56 too.... Thanks! Davi

Arno, Thanks for the measure, it’s useful info. Do you have your source of frigoboat info? I’d be happy to read it. The circulation pump is hot indeed, and always has been, and I also saw it hot

Kent For Genoa furling just experiment. My switch needed cleaning so I sat on the foredeck with 8m of 10mm. It didn’t take long to fuel and little effort. Ian Ocean Hobo SN96

Re Drain of drip tray. Under the floor below steps the hose is attached to the pipe that goes through to the bilge pump. Just unscrew the hoseclamp and pull off pipe. Then blow through it to clear any

Hi Charlie, Congratulations on your new Amel, and you have made a very good choice. We own 1992 hull #72, and our boat should be very similar to yours. Since we purchased ours in early 2014, we have

Hi Ryan, I have SM 243, she has a 24V 60 L/H Desallator. I'm not aboard now, but it sounds like that's what you have. Two 20" membranes? Kent

Today I measured the voltage directly across the circulation pump for the fridges and it measures 12.5 Volts when one or more fridges are running/cooling. That makes sense as the pump is 12

Oops, I think I sent before I was done. I have hundreds of posts to read through as my email program put 90% of them in my spam folder. We are a prolific group!!!! Kent

Stephanie, Thank you for your contributions. Congratulations of the sale. With best regards, Mark Skipper Sailing Vessel - Cream Puff - SM2K - #275 Currently cruising -

Hi Charlie, Welcome to the Amel Family. I've recently joined myself and yes these boats are a steep learning curve. As they are designed and build by French people that have a strong opinion on what a

I am replacing my running rigging prior to S Pacific cruise. Looking at the files section, I have a couple questions: What is the Tack Rope (10mm Kevlar, 11.5 meters)??? What line do you use for

Bill Kinney, I was originally thinking of using a non acid based silicone caulking for bedding my stanchions but I think that you may have hit on the perfect solution using the Butyl tape to

Wow perfect timing ...I will say again. We are about to embark on this "maintenance" item. Only lite rust on a few stanchion bases but I suspect they have not been addressed since 1990... THX on

Welcome aboard Charlie! This is the right place to ask one hundred questions....about Amels that is! I am sitting on Annie, SM #37, I purchased her in December 2016 so I too am about a