Bill, thank you for your service. Cordially, Bernie Lawson, former blessed owner Sharki

Linda, The wedge shaped C-Drive oil drain plug is going to be an Amel part. The Spurs info you have is correct. Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School

David, My B&G Sonic Speed is also not working. I was wondering what you replaced yours with? Paul Ya Fohi - Amel 54 #98

Dear all. I think it is time for some action from our moderator. The way Bill responds to a viable discussion doesn’t add value to this forum. There us no such thing as the absolute Amel way. Like

To add to Steve, You can purchase from Amel, part 3184 (red arrow) http://www.nikimat.com/spare_parts_c_drive.html Therefore. if you did not had the Spur Cutter originally installed, then I would

Barry, I have the brushes, thank you very much, at least I owe you a pint! Cheers, Paul Ya Fohi - Amel 54 #98

Hi Linda, On Rascal the oil drain plug for the Cdrive is designed to be the wedge holding block. Steve

Mark, Will do. Pat

Hi, I am about to order a Spurs Line Cutter and I understand it is a Model B, 1 1/2 inch. I am not sure if I need to order a Wedge Holding Block as well? If I do need to order one, which one do I

Commendable restraint, Bill. Carry on. Cheers, Craig ---In amelyachtowners@..., <brouse@...> wrote : Jose, I said I don't want to argue. I respect you and your right to your opinion. All I intend to

Jose, I said I don't want to argue. I respect you and your right to your opinion. All I intend to do is to state the other side, which is the "Amel Way." To say anything else, would likely be a

Our SM "It's Good" is sitting in the Severn River, just off of Mobjack Bay for the season, so Jennifer and I could more than likely make it as well. It would be good to meet everyone since we bought

Bill, I cannot see how you can state that you are certain I installed the seals wrongly the first two times when I followed religiously the "amel way" and ended up with water in the C-Drive oil

OK, Jose, we've got a date for two years from now (or 400 hours, or milky oil; whichever comes first!). My reading of the SKF engineer's recommendation was that the inner seal would face the oil and

Mike. I might be able to help. Friend us on FB . Loca Lola II. Ian S/V Loca Lola II SM153

Danny, Pertaining to this subject, I have just received an email from Flexofold after requesting a quote on a folding prop .I had sent them all the engine and trans specs., and told them that my max

Mike, Have you eliminated the possibility that the leak is freshwater. I am aware of a SM that had a hard grounding that caused a leak between the cast iron ballast and the keel stub, which is the

Jose, We all need to be aware that there are people new to this group. I think I understand to danger of people new-to-Amel not understanding or being misinformed better than most because I have

Ian, I hadn't though about the prop shaft alternator, as I removed mine some time ago (have a genset), but it certainly seems reasonable that the heavier SAE90 oil will present more resistance and

The biggest problem is the main sheet attachment. We've broken two of them becsause of over enthusiatic crew on the mainsheet button My solution : 1. make an aluminium piece of the same thickness but