Hi Scott; Thanks for the very timely and helpful update on your experience with the conversion. We are currently in the beginning stages of the design and all of this information is extremely

Teun, You're using the VEConfig software to adjust the inverter low voltage cutoff? I have successfully changed that on the Inverter tab "DC input low shut-down". Then you have to "Send Settings" to

As many of you know, I've been running lithium for 18 months full-time now, mostly in the tropics. We have 960w solar on the arch. We considered the Quattro 8k and decided not to for a few reasons: 1)

Oliver, I can NOT find the video Scott mentions in below Email. Can you send it again or direct me where I can find it. Thanks. Best Regards Teun SV AMELIT A54 #128 Currently on the

We've been drying the fridge out for a week now and a few drops of water STILL come out. It bubbles out at the interface of the PVC pipe where the condenser copper lines go down to the compressor and

https://svcerulean.com/for-sale/ It's in the selling sub folder but wanted to update the whole group ;) Cheers, Jer -- Jeremy Hermanns - "Jer" SVCerulean.com Maramu #105 Marina Del Rey, CA

Hi Paul, on BeBe the Victron BMV712 went into the same round hole in the 24v panel that the previous Link 10 had been in. The BMV came with a shunt and it uses a cat 5 cable with quick connect ends.

I had a emergency store run to make - see you all next time. -- Jeremy Hermanns - "Jer" SVCerulean.com Maramu #105 Marina Del Rey, CA

Hello Got the file. Thanks all for your help Best Soraya GARULFO A54-122

Paul, I mounted mine at the nav station as we log it every hour when making a passage. It is a more convenient place for me. Fair Winds Eric Amel Super Maramu #376

Paul, I installed aXantrex LinkLite – it uses all the same wiring and shunts as the Amel OEM. http://www.xantrex.com/power-products/power-accessories/linklite-battery-monitor.aspx

Hi Dan, How difficult was it to install the install of the Victron BMV-712 Smart Battery Monitor ? How difficult was it to do the wire run from the shunt to the new monitor ? Do you have any

Arno + Mohammad, The original owner changed in 2014/2015 the water maker from OEM DESSALATOR to SPECTRA NEWPORT II. The electrical unit with the 2 pre-filters was installed on the portside behind

We’ve had good experience with MasterVolt. The main reason we were considering Victron, was the capacity. I believe MasterVolt goes to 3500W per unit. I just checked and I see that they do have the

Thanks for the info Arno. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

Good to know many thanks Dimitris Alma Libre Too Amel 54 -- Best Regards Dimitris Krasopoulos dkrasopoulos@... Dubai Mob: +971 564602575 Greek Mob:+306944302318

Thank you, Ulrich. Good hint! Martin AMEL54 #149 „CHIARA“

Hi All, and anyone who has an issue with Opacmare gangway. Our 54 is from 2008 and so far only in the Mediterranean, mostly in Southern greece. So the gangway is often used, stern to. In 2017 a hose

You are trying to access the WaterPumpOverhaul.pdf file at the Yahoo website. Yahoo has deleted all of our files and photos. However, we moved everything we had to our new site. If you go to

Hi Mohammad, By the way, adding/replacing cables between the battery compartment and the engine room is very difficult. Amel sealed the duct between the two compartments with epoxy. This duct sits in