I have my new bearings and need to remove the car from the track. Is the track bolted or screwed down.I tried to back out a screw and it did not budge and started to strip. I was thinking I could cut

Mark and Debbie Hello, we cruised US East coast from Norfolk to Nantucket last year. It was a very nice trip. On our blogg sykerpa.com you can see where we were and our impression This year we aim to

Hi Kent - Leave the flange on the first sleeve and install it. Now clip the flange of the second sleeve down to the break-off groove that's machined into each sleeve. Your basic diagonal cutting

Thank you, Craig. Are you still using SpeediSleeves? How did you remove the lip/flange? I’m envisioning either grinding it off or cutting it off with a Dremel tool. Kent Robertson S/V

I believe the complete number for Mark & Debbie Mueller "Brass Ring" posting is Flojet Flojet 4105-512. This is 12VDC with 3/4" close to 20mm hose barb fittings. Of course, on a 54, you can wire

Hi Craig, got it. John

Hi Peter, As I said previously Penguin refrigeration in the UK sell them. Denis Aventura 54-113

Thanks, Arthur. Looks like I'm occasionally getting a 15 - 20 minute delay between hitting "send" and it actually posting. Seemed like they were disappearing. ---In amelyachtowners@..., <arthur@...>

Our compressor is mounted under the sink--on the lower shelf in your pictures. The upper shelf is missing on our boat to make room. Our fridge was a retrofit, and was installed with both the

Mark & Debbie, We have written about a lot of places over the last two summers in our blog, http://fetchinketch.net from the Chesapeake to New England. Hopefully you can find a few tidbits buried

works!

Hi, I was also looking for a circulation pump for the fridges. I bought a "europump" which is rated on the label to draw 1amp, but actually was drawing 2.5-3 amps and blew the fuse up. I changed the

WORKS! /A ARTHUR SUNDQVIST Timmermansgränd 3 11865 Stockholm Sweden

I've have had a few replies I made just disappear after hitting "send". Just testing to see if this posts. Craig

Good job, Bob. Cheers ---In amelyachtowners@..., <renaissanceiii@...> wrote : Craig, repaired bilge pump and used both membranes, didn’t lose anything, Bob Grey Renaissance 3 Sent from Yahoo Mail

Good job, Bob. Cheers ---In amelyachtowners@..., <renaissanceiii@...> wrote : Craig, repaired bilge pump and used both membranes, didn’t lose anything, Bob Grey Renaissance 3 Sent from Yahoo Mail

Craig, repaired bilge pump and used both membranes, didn’t lose anything, Bob Grey Renaissance 3 Sent from Yahoo Mail for iPad

Hi Steve, Yes, Nikimat was a later hull number with a different layout under the sink in the galley. I have a 1990, with the frig near the stove. The compressor is mounted on the upper left rear

Does anyone have pictures of how the original Frigoboat fridge was installed in a circa 1994 Super Maramu? The original fridge was removed from my boat before I bought it and a home fridge (220v) was

I feel such a fool! It must be the sun that has got to me - I asked about water pumps and mistakenly in my post asked about fresh water pumps - many people including Bill replied very kindly - What