If you mean the top of the hatch where the latch attaches take a look at the attached. About 3 minutes from the marina is Unique Molding & Doors, 1005 I St, Brunswick, GA 31520 912.222.0414 - I

No, the red/green buttoned ones. This one unipolar is used for the galley extractor (and also in the engine room). Unsure how many more onboard. Thanks

Thanks, folks! REALLY liked hearing about what chlorine might do to the stainless steel keelboats as I left a pretty strong bleach solution in the tank yesterday! Have to get back to the boat

Hi to all, after 12 years sailing around the world, I planned to improve the aesthetical aspect of “Eutikia” deck as the Faux Caulking (black

Leslie, This is exactly what I was hoping to find. Had a friend that actually had the anchor (not secured) dislodge in a short choppy swell. As he described it, it was so unexpected, and the

Thanks Ken, I think we all appreciate your videos. Safe travels. Michael Nebo

Thanks Mike. I think you may have been able to explain what caused the problem. I know it's been installed for 20years in my case. Upon removing the gearbox and motor to inspect, I found that it was

Hi Paul, the M12 is installed in my boat but it is a older one, the control units now more different. I have a switch on/off close to the Generator switch in the galley and a temp regulation in all

Hi If you mean those on the panel over the sink, I bought mine from BlueSea www.defender.com www.hodgesmarine.com Hope it helps Roque Attika A54 Paraty Brazil Em seg., 9 de nov. de 2020 às 15:52,

Hello is there a list of all disruptors installed on Amel 54 (by ref and spec)? I understand there are different references (either unipolar / bipolar). Need to source a replacement for 7122104 10D

Hello again Arnold! What size of heater do you have? I'm lean towards the Webasto 9 Kw, a bit small if one follow the guidelines from the suppliers, but I do not need room temperature all over the

I would have to agree with Bill, To fix you furler it will probably take a new motor, and maybe a new gearbox. I would rebuild the old gear box and carry it as a spare. I carry a new spare motor,

I have experienced exactly the same shaft sharing on both the outhaul Leroy summer motor as well as the furling motor. Clean brakes both. My sense is that with a very very slight misalignment of the

Thank You very much Ian and all, will definitely make use of all advices.

Courtney give me a call as I'm not sure what you mean 830 353 1587 Alan Grayson

that would be awesome is not locked as the board doesn't fit in the slot

Hi Courtney, do you want me to pop over and take some measurements? Regards Alan Grayson SM 406 Ora Pai Brunswick Landing Marina Get Outlook for iOS

There is no way that I know of to repair that shaft. I suggest that you contact SAV"at"Amel.fr Send them a photo along with your Request For Quote. Bill

I confirm, chlorine is not friendly with inox, specifically with 304 type. Some recommendations (temp, time and kind of inox) from dairy industry De : main@AmelYachtOwners.groups.io

Hi does anyone have the dimensions of the board you use to secure the hatch on a 54? Mine has become warped and I need to make a new one but am not on the boat. Cheers Courtney 54