Hi, I suppose it could be the timed circuit breaker in the shore/gen change over box is not it working well/on its way out. I’m not sure how those components fail, but if the timing is consistent

Hi Bill Thank you for your reply. My green lamp works very well. Even with a measuring device at the socket I cannot determine that 220V are produced in the first 5 minutes. Or is it the case

If you were looking at motor oil in the exhaust you would see a fairly rapid loss of oil level in the crankcase, and likely a LOT of smoke. I'll second Ian's suggestion that what you are seeing is

It is very common for this light to fail. In fact I believe it would be unusual to find an original green AC light working on a SM. The light has a life of about 6-8 years. Rather than replacing the

Hello all I have an onan generator on my SM 2000 that also works very well. Since a few weeks I have the problem that the display for 220 V only lights up after the generator has been running for 5

When I had the engine mounts replaced and other work done on the engine in Martinique, the Amel engineer started it and told me I would either need to clean the injectors or preferably put in new ones

Hello, I'd like your opinion on this engine issue. When we bought the boat in 2012, about every 30 seconds you could see a drop of oil come out from underwater, on the boat's exhaust. Like a flower

Many thanks Mark. I'm in touch with them. Regards Donato SM #468 Ocean Bird Raiatea FP -- ___/)_____/)____/)_____ Ing. Donato Valente mobile:+39 392 5390810 Skype ID: donato.valente

Thanks Duane, I'm on it! Kent Robertson S/V Kristy karkauai@... Panama cell: +507-61171896 USA cell: 828-234-6819

It is sold.

Kent, I sent you an email, but if anyone else is interested, be sure you have the B&G model #213. This model has 10 pins in the connector: 3 pins in the top row, four pins in the second row, and 3

Hi there I don’t have the manual but do have some other docs that might be of interest Attached incase of use to you or others All the best Miles Maramu

Hi Duane. I've tried to contact you by group reply and privately, nothing seems to be getting out. I'd like to purchase your masthead unit if it's compatible with my Hydra2000 control unit (circa

Hi Leo, Thanks for the drawing. Hopefully Maude can locate some sheaves for me in La Rochelle. Gerhard Hoffmann SY Pepino SM381 Greece

I have searched this forum and online for an owner's manual for the Maramu 46. Does anyone here have a digitized or pdf copy they are willing to share?

Sorry Duane, am not sure if my messages are being sent to you, can you contact me direct on pjn.mccallin @gmail.com please. Am interested in your M H U but can not locate it on EBay, can you please

Bill , Going to Home Depot tomorrow , if I don't find the one Bill bought there , I will look yours up on Amazon. Thanks, Pat

Hi Duane I have made the Drawing in Le Marin at Amel. That is what Amel Sales. Best regards Leopold Yinyang, SM #69 meinem iPad gesendet Am 20.04.2018 um 16:18 schrieb sailor63109@...

I've removed the B&G Masthead Unit in the switchover to a NMEA 2000 electronics system. I puchased this one right after Hurricane Irma ruined our old one in November of 2017. So this one is only 5

Leopold, From my memory I don't think the sheaves are 100mm in diameter on my boat (almost 4 inches), do I read your sketch correctly? Perhaps it's the difference in the hull