Capillary systems are notoriously difficult to get a correct charge with. Here is Coastal Climate Control's take on the

Hi Mohammad, I removed the two capacitors on the high-pressure pump andmeasured their capacitance. The first was18mfd and the second measured 25mfd. Iassumed they should have been 30mfd each. I

Mohammed, Thanks. I have in fact comae across this and it does seem like a good diagnostic guide but it does not tell me how much refrigerant to put in. Cheers, Paul Ya Fohi - Amel 54 #98

HiPaul; Thefollowing is an article that I had run into when I was debugging an issue withour refrigerator. It is on Coastal Climate Control's website. As mentioned onthe forum, they seem to be

Lifting horizontally??? I hear the logic and understand the physiology, but that really has to be balanced against the extra time, and complexity of lifting someone horizontally--which is virtually

I was doing some work on my MDKAV generator. I thought I would measure the isolated ground. I put a voltmeter on the isolated ground solenoid case and the 12 volt + battery cable. The voltmeter read

Hi all, Would anyone know where I can find an idiots guide to re-charging a friogboat fridge whcih uses R134A refrigerant? Cheers, Paul Ya Fohi - Amel 54 #98

Thanks Mohammed. I believe its probably cable connectors as its 10 years old now - I'll be having a look at them in the coming days. The white box I refer to houses the generator

Thanks for this info Dennis Sounds like you had all bases covered with hydrovane, autopilot and spare autopilot drive. I think I’m going to go against my instinct and not instal a wind vane. In

Hi Ian, I know there Is a drawing of the bonding strap is somewhere in the photos or possibly the files section of the Amel website. I made mine out of a very thick wide piece of copper plate

Hi Ian, Hole size should read 22mm

Hi Ian, Just completed the job in Port Grimaud. On hull 461 we required a 30mm “deep reach” socket to undo the keel bolt. The hole in the copper strip we used was 2mm diameter. We had our strip

https://groups.yahoo.com/neo/groups/amelyachtowners/photos/albums/1140528980 I believe this is the absolute best way to store tools. I also has Amel add a drawer under the lowest step. I use this

Hi James, I’m not a medical expert but this is the rational that was given to us. The basic physiology is that anyone who has been in the water for a period of time has the blood in the lower limbs

Tastes like chicken! With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising - Guadeloupe www.creampuff.us From:amelyachtowners@...

Can anyone elaborate on why the RYA suggests people are lifted horizontally? I find that hard to believe. The idea of using two lines to lift a casualty out of the water fills me with dread of

Hi all, Does anyone know the diameter of the keel bolt in the grey water bilge in the engine room of an SM ? I am making up the copper strip that bolts on to the aft bolt but I'm not on board and

HiMark On ourhigh pressure pump there are two capacitors. One is black 180 microfarad -0-20%, 220VAC, 40-60HZ FACON 70906.1412 One is white 70 microfarad +/-5% AC400V B, AC 450V C,

Hi Alessandro, I attach about 100 feet of line to the swivel at the top of the foil. I then rotate the foil until it is covered in line from top to bottom.. The end of the line I attach tightly to

Did you come up with the correct size capacitor for your watermaker? I have a 160 liter per hour version and the capicator is painted obstructing the name plate. Any information would be