|
Re: Offshore Health Insurance
Hi Eric - this is as confusing as what direction lip seals should face, but Medicare.gov says: Plan F "Foreign Travel exchange (up to Plan limits) Covers 80%", with an asterisk that says, " Plans F
Hi Eric - this is as confusing as what direction lip seals should face, but Medicare.gov says: Plan F "Foreign Travel exchange (up to Plan limits) Covers 80%", with an asterisk that says, " Plans F
|
By
Craig Briggs
·
#54978
·
|
|
Re: Offshore Health Insurance
I wish someone else would check this out and see if you are told the same thing as I was Told.
Fair Winds,
eric
I wish someone else would check this out and see if you are told the same thing as I was Told.
Fair Winds,
eric
|
By
eric freedman
·
#54977
·
|
|
Re: Offshore Health Insurance
I hope you’re right. Wife and I have the same plan. It’s great in the states.
~~~⛵️~~~Matt
I hope you’re right. Wife and I have the same plan. It’s great in the states.
~~~⛵️~~~Matt
|
By
Matt Salatino
·
#54976
·
|
|
Re: VP TMD 22 muffler
Hi Paul, I had some pitting on my stainless steel muffler. Most around the inlet under the pipe. A stainless metal shop can cut out the bad material and put a new piece into it.
I would have them
Hi Paul, I had some pitting on my stainless steel muffler. Most around the inlet under the pipe. A stainless metal shop can cut out the bad material and put a new piece into it.
I would have them
|
By
michael winand
·
#54975
·
|
|
Re: VP TMD 22 muffler
Thank you Ryan
I just had a glance inside and from that, it looked almost as good sa new, so I decided to keep it, Probably possible to fix with Epoxi if starts to leek when waiting for a new one. We
Thank you Ryan
I just had a glance inside and from that, it looked almost as good sa new, so I decided to keep it, Probably possible to fix with Epoxi if starts to leek when waiting for a new one. We
|
By
Paul Osterberg
·
#54974
·
|
|
Hose adapters for metric hoses
Hi,
I have found these adapters very helpful for use with many hoses on Kimberlite.
They come in 2 sizes.
Fair Winds
Eric
Amel Super Maramu #376
Hi,
I have found these adapters very helpful for use with many hoses on Kimberlite.
They come in 2 sizes.
Fair Winds
Eric
Amel Super Maramu #376
|
By
eric freedman
·
#54973
·
|
|
Re: Offshore Health Insurance
HI,
I just got off the phone with AARP. I have plan F supplemental. .
According to them it covers 100% of the bills after a $250- dollar deductible out of the USA. I must pay the bill and then
HI,
I just got off the phone with AARP. I have plan F supplemental. .
According to them it covers 100% of the bills after a $250- dollar deductible out of the USA. I must pay the bill and then
|
By
eric freedman
·
#54972
·
|
|
Re: Fusion Marine Stereo (24 volt?)
Ryan and Kelly,
Not powering upthe instruments is an easy fix:
Ryan and Kelly,
Not powering upthe instruments is an easy fix:
|
By
Mark Erdos
·
#54971
·
|
|
Re: LiFePO4 Conversion on sv BeBe - SM#387
Hi Matt, for me it was about being fully in control of my battery management system. I did not like the "black box" approach of the "drop-in" batteries.
I wanted to know my system and be able to buy
Hi Matt, for me it was about being fully in control of my battery management system. I did not like the "black box" approach of the "drop-in" batteries.
I wanted to know my system and be able to buy
|
By
Dan Carlson
·
#54970
·
|
|
Re: VP TMD 22 muffler
We just went through this replacement process a few months ago. If you're willing to spend the money, probably the best option is to have a new one fabricated in metal or fiberglass so you can
We just went through this replacement process a few months ago. If you're willing to spend the money, probably the best option is to have a new one fabricated in metal or fiberglass so you can
|
By
Ryan Meador
·
#54969
·
|
|
Re: LiFePO4 Conversion on sv BeBe - SM#387
Hello Stephan, attached is a photo from the underside of the arch, with the new panels.
I had some one cut some 25mm (1") by 35mm (1.5") by 10cm spacer blocks from teak. These raise the new panels
Hello Stephan, attached is a photo from the underside of the arch, with the new panels.
I had some one cut some 25mm (1") by 35mm (1.5") by 10cm spacer blocks from teak. These raise the new panels
|
By
Dan Carlson
·
#54968
·
|
|
Re: Fusion Marine Stereo (24 volt?)
The Fusion stereos (and presumably other brands of actual marine stereos) have two major advantages of car stereos: 1) they use class D amplifiers, which use significantly less power compared to class
The Fusion stereos (and presumably other brands of actual marine stereos) have two major advantages of car stereos: 1) they use class D amplifiers, which use significantly less power compared to class
|
By
Ryan Meador
·
#54967
·
|
|
Re: C-Drive drain plug o-ring
Oops. I replied with the drain plug size/thread pitch. Unfortunately, I don't have any record of the o-ring size.
--
Mark McGovern
SM #440 Cara
Deale, MD USA
Oops. I replied with the drain plug size/thread pitch. Unfortunately, I don't have any record of the o-ring size.
--
Mark McGovern
SM #440 Cara
Deale, MD USA
|
By
Mark McGovern
·
#54966
·
|
|
Re: LiFePO4 Conversion on sv BeBe - SM#387
Dan,
In addition to Steve's question above, I am hoping you can provide a couple of further insights into your design process.
What drove your decision in using prismatic cells verses off-the-shelf
Dan,
In addition to Steve's question above, I am hoping you can provide a couple of further insights into your design process.
What drove your decision in using prismatic cells verses off-the-shelf
|
By
Matt & Michelle Day
·
#54965
·
|
|
Re: C-Drive drain plug o-ring
Ian,
I'm 99% sure it's M20 x 2.5 thread pitch.
--
Mark McGovern
SM #440 Cara
Deale, MD USA
Ian,
I'm 99% sure it's M20 x 2.5 thread pitch.
--
Mark McGovern
SM #440 Cara
Deale, MD USA
|
By
Mark McGovern
·
#54964
·
|
|
C-Drive drain plug o-ring
Does anyone know the size of the SM c-drive drain plug o-ring?
Ian
SM153
Loca Lola II
Does anyone know the size of the SM c-drive drain plug o-ring?
Ian
SM153
Loca Lola II
|
By
Ian Townsend
·
#54963
·
Edited
|
|
Re: LiFePO4 Conversion on sv BeBe - SM#387
Hi Dan,
Congratulations on your recent LIFePO4 upgrade. We just spent months going through Alaska with a slowly failing lead acid battery bank, and have also decided to upgrade now that we are in
Hi Dan,
Congratulations on your recent LIFePO4 upgrade. We just spent months going through Alaska with a slowly failing lead acid battery bank, and have also decided to upgrade now that we are in
|
By
Stephen Davis
·
#54962
·
|
|
Re: Valsat 03 dimesions
We have a 7 inch raymarine axiom. A 9 inch would also fit. We used a cover plate. Of 250mm by 160mm
Michael Nebo sm251
We have a 7 inch raymarine axiom. A 9 inch would also fit. We used a cover plate. Of 250mm by 160mm
Michael Nebo sm251
|
By
michael winand
·
#54961
·
|
|
Re: LiFePO4 Conversion on sv BeBe - SM#387
Hello Daniel
many thank for your calculation sheet. If I calculated right; without shipment, without you new solarpaels; the cost for your LiFePO4 project was 7154 US$, without your personal labor. Is
Hello Daniel
many thank for your calculation sheet. If I calculated right; without shipment, without you new solarpaels; the cost for your LiFePO4 project was 7154 US$, without your personal labor. Is
|
By
hanspeter baettig
·
#54960
·
|
|
Valsat 03 dimesions
Hello,
as I can not go to the boat in next weeks (corona lockdown in Slovenia) I would like to ask if anyone have the dimension of GPS Valsat03 that I will replace with chartplotter.
Thank you.
--
Hello,
as I can not go to the boat in next weeks (corona lockdown in Slovenia) I would like to ask if anyone have the dimension of GPS Valsat03 that I will replace with chartplotter.
Thank you.
--
|
By
Slavko Despotovic
·
#54959
·
|