Congratulations from "Noa" as well! Kind regards, Walter (Noa, SM2K 436)

Hi Alexandre, all fine - I think it was just in the chain of replies that things got mixed. Regards, Walter (Noa, SM2K 436)

Hi Alexandre, all fine - I think it was just in the chain of replies that things got mixed. Regards, Walter (Noa, SM2K 436)

Hi Alexandre, on Super Maramus with holding tank there is no loop - because the way the hoses are connected to the tank and the tank/its vent act as a loop/valve. Regards, Walter (Noa, SM2K 436)

Hi Alan, to be more precise: the optocoupler is between the seriell cable from the pactor and the usb to seriell converter from the laptop. Our SCS Pactor III has seriell connections on both sides, SS

Hi Alan, your SSB is probably connected to the laptop via pactor and seriell to usb converter. What happens when you plug and unplug the usb cable at the laptop? We experienced a leak/the lamp on - al

Hi Alan, before going into AC I would check the DC connections - you mentioned the usual suspects (electric pumps) and the leak detector is for the DC-circuit. Do you use a laptop and to which other d

Sorry for the typo, it´s www.onmar.se

Dear group, Amel used different turn latches on different models. Noa (SM2K 436) has Mobella turn latches - good design but there is a tiny device inside the latch which brakes sometimes. Last time I

Alan, if you are good in silver soldering and don´t get the cable out you could solder the new motor cable to the old one. If you stick them together like two opposite paint brush, it will suck the si

Hi Alan, sounds good. Going backward and forward and turning an bit and remember the number of turns - if there is a tie and you try pulling both cables from their motor side you might see it/somethin

Hi Alan, I took the outhaul motor and gearbox apart last year, refurbished the motor and got a new gearbox. No problem with the cables - maybe yours are wrapped around each other by coincidence and yo

Hi Jim, there is a little hose clamp at the fitting of the hydraulic hose - this connects the oil cooler of the gear box to the bonding system. I suppose this will fit to the stripped section of the w

Hi Mike, Noa has a Yamar engine which is serviced different, but we had a Volvo TMD22 on our previous boat. The camshaft cover on the TMD serves as the upper part of the camshaft bearing. When you dis

Jay, just for clarification: Plexiglass is a product name, not the material, which is acrylic - this is used for the dodger windows of the SM. You bought polycarbonate, which is fine: more sensitive t

Hi Bob, Noa (SM2K #436) has the same setup as Elise, dessalator duo 60. The hp pump is driven via belt, either by 220V AC motor or by 24V DC motor, a compact and reliable setup. We use 24V DC when und

Hi Paul, we changed the pressure switch once on Noa, SM2K 436, because the contacts became worn. It is an industrial standard model and sold all over the world, Square D, the company is Schneider Elec

Hi Mike, I got it out by disassembling the boom, taking it from the boat and solid punching, but you need to put the support in the right place, otherwise you might brake something you don´t want to b

Good morning Eric,the fault detector for the 24V DC circuit is a simple device.There is a two way switch which normally flips into neutral/center. The center is connected to the Amel bonding system. T

Hi Alan, yes, I know about the exeption with the Calpeda pump. Amel decided to add it to the bonding system and as they were doing it for a long time there seemed to be no negative response from the t