I would like to consider replacing 220v lift pump for a Dessalator 160. Has anyone found a good replacement for the Dessalator factory pump or know the specs for the pump – flow rate & pressure? Prefe

Thanks.

We added 24 volt single color LED’s with a dimmer. They are working great – as said before, a HUGE difference. I choose 36 LED per foot to avoid any shadowing. I used the adhesive back to mount the st

I connected directly to the 24 volt system. I left the existing kitchen lighting in place and connected the new LED lights to that source using the existing circuit breaker for protection. I was reluc

Try checking the "OEM Mode" from the small readout on the EVC Control Panel at the helm. This may give you information about what fault has occurred. The Workshop Manual lists some o f the codes, try

Hi Doug, Checking wide-open throttle at the dock may not necessarily reflect what you see underway. The vacuum pressure in the engine is usually dramatically different under full load conditions versu

We had to replace the Bamar EJF-1 about 4 weeks ago that was installed approximately 3 ½ years ago. Water intrusion seemed to have incurred at an unknown location causing what appeared to be electroly

Using a direct heat exchanger circuit where drinking water goes thru the refrigeration cooling circuit & is discharged back into the drinking water would normally be considered an unsafe industry prac

Would a compression test be valid to identify a problem with a specific cylinder, associated head gasket, or the head? It could give you a place to start looking or indicate the problem is elsewhere.

Attached is the Side Power Trouble Shooting Guide. Page 6 - 8 helped me with a problem with the bow thruster.

Congratulations!! I was unable to get the belt past that little nub on the engine, Hopefully it will work for everyone.