From: Kimberlite <Kimberlite@...> Sent: Sunday, August 15, 2021 3:36 PM To: 'Pierre Blouin' <blouin_dion@...> Subject: FW: [AmelYachtOwners] Onan Generator exhaust temperature switch

Hi Kent, No pix attached. Fair Winds ERIC Kimberlite Amel SM 376

Hi Pierre, I would like to order 6 of them just as spares. How do I pay you for them and the postage? Paypal? Fair Winds ERIC Kimberlite Amel SM 376

I was thinking of that but I wanted to be conservative.

I wonder how fast Kimberlite would go with 1800 horsepower . CAN You Believe this setup? Fair Winds Eric Kimberlite Amel Super Maramu #376’

Sorry, I did not read your entire post. I would still disconnect the coupling and disk brake to see if the drive spins freely. I would also check your prop. The removal of this coupling has been cover

This is a Vetus coupling that is remanufactured by Amel. It is only available from Amel. Unfortunately, they are closed until the end of the month. The coupling is very strong, and I am surprised it i

Hello Pierre, I believe I saw a photo of your deck hatch reinforcement. I would like to order a few. Please send me a photo to verify and the approximate cost. Fair Winds Eric Kimberlite Amel Super Ma

I have had some HVAC technicians add a leak sealer with the freon for very small leaks. Fair Winds Eric Kimberlite Amel Super Maramu #376

Lance, The reinstallation of a shaft generator seems like a simple project. You would need to know the speed of the shaft when cruising. Once you have that information, I would go to a shop that rebui

Pat, The isolated ground alternators usually have a piece of black plastic under the mounting stud. It is quite easy to visually separate the isolated ones from the non-isolated ones. Fair Winds Eric

#lessons

The Amel factory zinc is about a R5 size. I use a R7 and just drill it out a bit. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Joel, Nice to see you on the board. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Pat, Just for laughs. Test the voltage between the lead posts on the starter battery and the connections at the back of the switch. I found that the cables were internally corroded as Amel uses wel

HI, Amel suggested removing all the old sealant and replacing it with 4200. So far 6 years no problems. Fair Winds Eric Kimberlite Amel Super Maramu #376

Amel recommended 4200 and not silicone for this job. Fair Winds’ ERIC Kimberlite Amel SM 376

Hi, I suggested a hot water system -hydronic- not a fresh air. If you go with the hot air system, there are ways to make the bulkheads watertight. That arrangement came with Kimberlite when I added th

Pat, After rewiring 2 engines in my boat, I believe you would be hard pressed to find someone who understood the system, beside another Amel owning nut job like myself. Fair Winds ERIC Kimberlite Amel

Amel installed my Raymarine speed transducer about 1 foot aft of the one in the photo. Fair Winds ERIC Kimberlite Amel SM 376’

Hi, A friend of mine with an Amel just installed a Espar hydronic heater in his boat. He even put a blower in the cockpit. The hydronic unit seems to be a much simpler installation than a forced air u