No success this morning. I go through all of the necessary steps indicated in the manual, the lights flash as expected on each step ... except the last step which is confirmation that the code is prog

Hi Dimitris and Roque, Good pointers thank you. Findings so far: I can confirm that the transmitter unit is T60TX-04STL and the receiver unit is T60RX-04ASL. I have executed the learning sequence for

Nick, My GP150 suffered a similar fate, it works except for data output. I installed a couple of cheap stand-alone "mushroom" type 0183 GPS receivers behind the panel in the chart table. One is a hot-

Hi All, I have Simpson Davits on my A54-154 and the remote control function has stopped working. The Davits operate fine with the hard-wired buttons. The batteries in the remote are fine and the red (

Joerg, FWIW I ordered some from here https://www.modelsport.co.uk/contact/ X

Hi Martin, Thank you. I will send an email to Franck. best regards Dean

I had to disconnect my back stays for the lifting in 2019 and launching of Stella last week. I'm sure the tension is not the same as it was originally. Does anyone know the (numerical) tension they sh

Hi Ruedi, Thank you for closing that loop for me. It is now clear that the new Volvo part number 872242, is in fact exactly the same Valeo relay suggested below by Dominique. I have found a source for

Nick, great idea. Do you do anything special to prevent the napkin from moving/falling? I'm not impressed with the impact of almost two years on the hardstand in Scotland. I have a bunch of "stuck" sy

HI Dominique, Thanks for confirming that. My solenoid does not have this button, but it is definitely faulty. I shorted across the main terminals and the engine now cranks but does not run. It turns o

Thanks Dominique, Is this fitted to a D3-110? The one I have on #154 seems to be a Volvo part, but I just can't see the part number. It would be nice to know that it fits directly on the D3-110. I'm g

Hi folks, Today we launched Stella after almost 2 years on the hard. Tried to start the motor ... nogo! I believe I've traced the problem to the Earthing Relay whose job seems to be to momentarily con

Hi Brains Trust, Thank you all for your swift and accurate guidance. A problem shared and all that. best regards Dean SV Stella A54-154

Barry and Penny, Wow, those are big cables! im taking the easy route over the ceiling for my data cables. best Dean SV Stella A54-154

Hi Jamie, I don't need to run DC power cables, so I prefer Dominique's suggested Routing to busting out that epoxy!! Best regards Dean SV Stella A54-154

Dominique, That's perfect thanks. Do I need to remove all the ceiling panels in the galley and across to the chart table, or is there a trick? Thanks Dean SV Stella A54-154

Hi Brains Trust, I'm back on board after almost two years! Starting the install of my new LFP system and I need to run some new cables (Data/signal only) between the batteries and the engine room. I k

Hi Nick, Thanks, good to know. It was probably a combination of finger trouble and lack of detailed interest on my part. I assume my receive antenna is fine as I can receive Navtex ok. I will give the

Doug, I'm interested too. I've been able to receive Navtex transmissions with it, but was never successful in finding a weatherfax. I concluded that the equipment was probably working ok, but didn't s

Chris, This is the path I am going down too. I will install one MP 3000 when I upgrade my system this year, and then think about whether I need/want a second one after I am using the system. Like many