This is unbelievable . Here is the FedEx tracking history to St Maarten – still not there. Start at the bottom. Fair Winds Eric Kimberlite Amel Super Maramu #376 Thursday, February 3, 2022 1:42 AM MEM

Kent, What hook are you talking about? Fair Winds Eric Kimberlite Amel Super Maramu #376

David, I cut the one I use out of 1/4-inch aluminum with a bandsaw. I used the nut as a template. Attached is a photo , it is also in Bill's book. It took me about an hour to make , including a drill

Sent: Saturday, December 11, 2021 8:24 AM To: main@AmelYachtOwners.groups.io Subject: Re: [AmelYachtOwners] What is his? #spares Thank you, all clear now. Regards Jarek SY NOA BLUE SM 201

#spares

Hi Drew, Thank you for the information. Oddly enough my original problem was that the internal cam that is screwed into the knob breaks. I solved this by casting a few dozen in brass. Now I am running

Hi Eric, I think the cost to ship it to Holland would be more then the cost of 4 inches of aluminum. I plan on making a tubular piece of aluminum the inside diameter of the foil with a groove milled o

I SEE THE ANSWERS BUT NOT MY ORIGINAL POST. Fair Winds Eric Kimberlite Amel Super Maramu #376

HI Eric, I have a question. That is that screw in the cord above the collar? If you lightly heat the epoxy will become soft and you can remove the collar. I note that you are missing a v-045 oil seal

HI, I just had the pleasure _ha_ of rebuilding the manual main furling gearbox. It is not difficult. The only hard part was getting the outer race out and the new one back in. Above please find a phot

The last 2 days I had the pleasure of rebuilding the manual furler for the mainsail. I would first like to thank Mother Ship Adrift for his video. It was very helpful. I saw in a later video that his

When I bought Kimberlite from Amel, I noticed the Vetus plastic mufflers. I ordered spares before I left the dock. Sure enough 3 years later we were motor sailing and a crew member said I think there

You can buy a piece of 1/4 inch aluminum and cut the wrench out with a band saw ; it is very easy. Just remove the packing nut and use it as a guide. Attached is a photo of the wrench that I made . To

Hi Chris, It looks like only a fiberglass problem. However, I would check the rudder stops at the quadrant. Possibly one is loose. Otherwise, something might have gotten jammed in there and when the r

There is a member on this group that makes magnificent Stainless steel Cars. If you plan on using the Amel cars, make sure you use something like duralac or some other material that will not allow the

Kimberlite was delivered from the factory with 2 dolphin chargers capable of 50/60 cycles. Fair Winds Eric Kimberlite Amel Super Maramu #376

#alignment

Hi Bertrand. Just take your 16 amp female plug and add a piece of what we would call 12 gauge twisted wire to the plug, Basically get a wire cable that has wires equal to or bigger that what you curre

#alignment

Jose, Most USA marinas and some Caribbean have 30 and 50 amp not 60 outlets. They are not 3 phase. The 50 amp have 4 wires on the plug, green-Ground, black and red hot, and white neutral, Between the

#alignment