Our main furler and outhaul were very weak at the start of the season last year. We traced the issue down to both TOPs limiting current to the motors for unknown reasons. We were at the dock, did not

Thank Bill. Sound advice. Happy Sailing; Mohammad and Aty B&B Kokomo Amel 54 #099

Last season, our original brake system was no longer stopping the shaft and prop from turning when sailing above 4 knots. We put in place a temporary solution so we could finish up the season. This se

Efkharisto Dimitris. Respectfully; Mohammad Shirloo +1-323-633-2222 Cell +1-424-644-0908 Fax

Thanks Nick. I’m kind of in the same camp. I think an appliance at 15 years, has provided all the life you should expect. At any failure, replace and go hassle free for hopefully another 15. This is p

Thanks Doug and Bill. I'll try it. Simple enough. Respectfully; Mohammad Shirloo +1-323-633-2222 Cell +1-424-644-0908 Fax

Thanks Arno. I appreciate the quick response. Respectfully; Mohammad Shirloo +1-323-633-2222 Cell +1-424-644-0908 Fax

Our front load refrigerator has stopped cooling. It ran fine all season last year. When we got back on board this season, the coil gets cool, then some condensation but does not appreciably cool the b

We had the same issue with the speed bearing. We managed for 2 years by taking the bearing down and soaking in water overnight which helped and the unit would work fine until wind dropped below 4 knot

Hello Jose, Amel recommends running the Genset to assist in maintaining the voltage to the Bowthruster. The higher the voltage the lower the current requirement. This will reduce heat buildup and wear

Very creative bill. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

We applied 3 coats of micron in 2018 in Malta. Due to COVID, we did not haul out until 2022. After 4 years, one of which we could not make to Kokomo due to Covid, and sailing the rest for about 5 mont

Hi Barry, Just saw your e-mail right after I posted. Thanks for sending me one. If you have a second one to spare, I’d like to have a spare as well. Let me know. Happy Sailing; Mohammad and Aty B&B Ko

Hi Barry, Did you forget about me? Lol. I had requested a couple of the latches as well. Can you please ship 2 to me and let me know how I can pay and the total. Thanks for going through the headache

Hi Scott, If your speed cable and transducers are original, be very careful exerting any pressure on the rubber caps. Ours came off while wiping the hull with a sponge underwater when my hand accident

Hello Paul, We had the exact same issue in 2021. One side would work and the other intermittently. I finally diagnosed the issue to the main solenoid and pulled for inspection. Here’s what I found. 25

Hi Robin, The one used by Amel on our D3-110 is the DC-60. This is the correct size and we replaced ours 2 years ago. Attached is the invoice from Lancing Marine in the UK. We ordered a spare, just in

HI Barry, Payment sent. Shipping address sent to your personal e-mail. Thanks again and take good care. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

Hi Barry, Post to US in April is fine. Please provide PayPal address and total. Hope to catch up with you guys somewhere. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

HI Barry, I will take one if you still have one left. I'm in the US, but if easier I can provide Italian address. Let me know. Thank you. Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099