I also need to replace the rudder packing on my Mango. Any fellow Mango owners that know what size they used?

It looks like it has been well loved. However check the followong... * Wiring, does it look like a rats nest or original neatly wired? * Look in the anchor locker under the forward deck where the chai

I have been onboard 5 mangoes now inspecting them, and have lived aboard hull number 46 for 4 years now. The Mango was not built with a watertight engine room. Not a bad thing IMHO. The "rectangular h

I recently purchased (past March) a spare starter for my 1985 mango with the 4.236 engine. Give Jeff Beard a call, he is with perkinspower/ tradewindspower out of Miami. His number is 305-592-9745 ext

I took a different route and happy i did. I installed a 7 inch zeus in a navpod at the helm offcenter to port and installed a 12" zeus in a navpod on the starboard side of the companionway. It preserv

I recently installed a B&G ram 2 and rhe associated autopilot on my Mango. It has run flawlessly during my Bahamas cruise this past season. I have not decided if i want to secure the ram with a sepera

Awesome, thanks Gary. I pulled the sensor out today and took a bunch of measurements and have a local shop sending a unit to me over night. If it fits, I will post what I used. If it does not, then wi

Hello fellow Mango owners. My port side fuel sensor has finally given up the ghost and died. I did all the troubleshooting and narrowed it down to the sensor. Has any of the Mango owners on here repla

I have Mango number 46 from 1985. The Mango is a great boat and IMHO (I know this will be controversial) the best design that Henry came up with. Yes, they are older boats but if they have been mainta

Hello all. I am getting ready to order a SCUBA compressor - Coltri MCH6 (110 volt electric). My boat its the Amel Mango. Do any of my fellow Mango owners have a dive compressor on their vessel? If so

Hello all. Does anyone have the rudder dimensions for the Mango Rudder or perhaps a Super Maramu rudder? I am after the length (forward and aft) and the height (top to bottom) of the rudder. I looks a

Nice installation for sure. I will give them a call.

Hello all. I have a 1985 Amel Mango hull # 46. I am installing a new B&G autopilot using the B&G T2 marine linear actuator. The space is tight but It will fit fine. I unfortunately need to cut some of

Hello all. I will be installing a Navpod at the helm in the next week and aside from clearance on my traveler (far left of photo) and trying to preserve visibility to 3 or 4 of my raymarine instrument

Oops...thanks!

Thanks thats exactly the point of view picture I was looking for. Has anyone else done this with the b&g hydraulic rams? Looking at options

Hello Danny. Thanks for the pixs. Do you have pictures of the entire area by chance? I want to see how you tied the ram into the rudder. Do you still have the original cable steering attached as well

I attached 2 pictures that show the space available. Keeping in mind that this is a Mango

Hello all. I am installing a new B&G system and looking at putting in the autopilot. The original autopilot works fine, but this will provide me some redundancy. I am looking to see if anyone has pict

Has anyone found a proper gasket for the Amel deck and cockpit lockers? I see lots of initial investigation so I am hoping that someone can post what they finally settled on. I see 1 post about orderi