I have a leak on the genset raw water pump and am in Guadeloupe. Yesterday I managed to source the pump shaft from the onan dealer in pointe a pitre. However am having more difficulty sourcing the sea

My small efforts to reduce spam type messages, unsigned, were clearly futile. During one period of my life I wore diapers. I wasn’t o member of this forum then either. David Ker Marie SM#101

Mark and Paul. Spot on. More respect for ‘moderator’ Bill wouldn’t go amiss either. The forum is a non commercial, excellent resource for Amel owners, being information based and apolitical, with clea

Hi I am updating the electronics onboard and would like to remove an alarm system. I was under the impression the bo, as pictired below, was the central unit for an alarm system however there are cabl

Paul, I recently had an intermittent one way bow thruster issue and it was being caused by the switch under the joystick beginning to fail. On the SM it is pretty easy to lift the black bow thruster d

Jose Thanks again for the silicone seals. Would you please confirm that the seals are intended to replace the 'hard' lip seal below the upper foam seal in the orientation as per attached photo's? Many

The needle on the tacho for my Volvo Penta TMD22 goes to the far side of the dial on turning the key but does not return to zero/rev count. Periodically the needle shows a rev count after the engine h

Jose Well done for offering to replicate the seals for others. I would love 2 sets if possible. I would suggest using transferwise, or its equivalent, for payments - easy for international transfers a

The diesel dipstick works very accurately when it matters - with low fuel. A few months ago it read around 3 litres left in the tank and no problems. David SM#101

Hi Can someone advise the (copper) gas pipe size feeding into the gas locker on a SM? I am sizing the fittings for the suggested Burkert solenoid valve (6013/125301) but am not on board to measure the