Maybe I got lucky with the port I was in. Novigrad is only open during the season but I worked fine and I got the required permit to sail Croatian waters. Best Regards Jim Watkins Act II Maramu hull 1

I have one of these and it works great but have only used it in Croatia. Best Regards Jim Watkins Act II Maramu hull 185 Sent from Mail for Windows

I have a 1985 Maramu with exactly the same problem. Was fixed sometime ago the first time and it happened again over time. Proper fix did require spreading out the load on the bolts through the bulkhe

I used KC Marine and was very satisfied with how through they were. Kelly Carver KC Marine. survey@... 954 766 8100. Best Regards Jim Watkins Maramu hull 185 Sent from Mail for Windows

I had work done at a duty free (VAT) yard in Pula. Commodore and they did a nice job of everything they handled especially the new paint job. If you are non EU flagged the savings can be considerable.

I have used the Tides “Strong Seal” and it has been quite good. Only issue with the seals is to make sure they are properly installed. Jim Watkins Maramu 185 Act II Sent from Mail for Windows 10

Try Edward.williams.com. I got insurance for my Maramu for the total Caribbean including hurricane coverage. They are a Spanish company and work with global insurers. Best Regards Jim Watkins Maramu A

There is a great service.operation in Pula. Commodore and it is VAT free if.you are not EU flagged. I had quite a bit of.work done with them and it was all well done. Best Regards Jim Watkins Act II.

My Maramu is a 1985. I expect to receive the die design within the next week or so and I will post it and you can check it then. Best Regards Jim Watkins Maramu hull 185

Thanks the Maramu rail is quite different.

It is quite different I am pretty sure it is different. Do you have a die line drawing? Thanks Sent from Mail for Windows 10

I know this is a SM thread but I have ordered a new rub rail for my Maramu and I too have have had good experience with Technorubber. I will have the die drawings in the next couple of weeks and I wil

Dirk I did a refit on a Maramu hull 177 of a yanmar and used the original transmission. I can send picture if you want them. Best Regards Jim Watkins Maramu 177 Act II Sent from Mail for Windows 10

It required removing nearly All of the forward head trim. A plastic unit that fit behind the panels which were replaced. I think I may Have some Pictures and will try To find them Best regards Jim Wat

I have Maramu hull 185 and while there was no holding tank in the forward head there was one in the aft head. I had it done by a knowledgeable Amel person and can recommend hs contact. I assume you ar

I would like the address also. Thanks Jim Watkins Act II Maramu 185

#cal-invite

I will also send you final drawing and a one foot sample of the first extrusion. Best Regards Jim Watkins Act II Maraamu hull 185 Sent from Mail for Windows 10

1985 Jim Watkins Act II Maramu hull 185

So far have only sent sketch Jim Watkinsand pictures. I will send die drawing when finished, Jim Watkins\ Act II Maramu 185