Dennis, Do you have a picture of how you have run your lines. Would be very interested in seeing specifically how you have this setup. Thanks! wade Maramu #124

Arlo, i am guessing that the 2 1/4 will work. I purchased that size from JD but have not tried to install it yet. What I do know is that when I tried to install the 2 1/8” exhaust hose previously I ha

Re: cutlass. - I don’t know if the shaft was ever changed. But 1 3/8” = 1.375” and 35mm = 1.37795. Shaft is tight and does not wiggle side to side or up and down. I wonder if the less than 3 thousandt

Thanks James. I Will be sure to change it out. I wondered about that but when I looked up stuffing boxes in the Paxton catalog to confirm the yards recommendation I saw at least one stuffing box that

Just did this replacement on 83 maramu. Used a Johnson duramax size 1 7/8”x 1 3/8x 5 1/2” bearing. Replaced stuffing box hose with exhaust hose as per yard recommendation.

Rustoleum cold galvanize spray over the proper 2 part epoxy primer. Has a lot of zinc 10$ plus primer

Tom, I recently pulled the fuel tank on my 83 maramu. I had an unknown leak at the forward end of it that had rotted a small section of the companionway bulkhead just to the left (starboard) of the st

Rainer is correct. on the 83 maramu the slider rails are both glued and finish nailed to the facing which is 8 mm veneered ply. Dont try to remove the rails or you will deface the laminate..... on the